Care And Cleaning - Scott A6 2019 Manual Del Usuario

• V. CHECKING THE FIT OF YOUR HELMET
PRIOR TO USING THE HELMET MAKE SURE THAT IT FITS PROPERLY AND THE STRAPS
ARE ADJUSTED PROPERLY. PULL THE CHIN STRAPS TIGHT ENOUGH SO THAT THE
HELMET FITS FIRMLY. PUT THE HELMET IN THE PROPER POSITION (A) AND LOOK AT
YOURSELF IN A MIRROR TO CHECK THAT THE HELMET FITS PROPERLY.
CHECKING THE FIT OF YOUR HELMET : GRAB THE HELMET WITH BOTH HANDS WHILE
IT IS SITTING FIRMLY ON YOUR HEAD AND TWIST IT LEFT AND RIGHT. IF THE HELMET
FITS PROPERLY, IT WILL MOVE ONLY MINIMALLY OR NOT AT ALL. IF IT MOVES TOO
MUCH, THEN PLEASE GO BACK TO POINTS 3 AND 4 AND REPEAT THE STEPS FOR ADJUSTING THE FIT OF THE HELMET.
CHECKING THE STRAPS : GRAB THE HELMET WITH BOTH HANDS WHILE IT IS SITTING FIRMLY ON YOUR HEAD AND
ATTEMPT TO TAKE IT OFF BY PUSHING IT FORWARDS AND BACKWARDS USING SERIOUS EFFORT.
THIS IS IMPORTANT ! IF YOU CAN PUSH YOUR HELMET SO FAR FORWARD THAT YOUR VIEW IS OBSTRUCTED OR SO
FAR BACK THAT YOUR FOREHEAD IS EXPOSED, THEN YOUR HELMET DOES NOT FIT PROPERLY. IF THIS IS THE CASE,
THEN PLEASE GO BACK TO POINTS 3 AND 4 AND REPEAT THE STEPS FOR ADJUSTING THE HELMET.
WARNING! IF YOU CANNOT ADJUST YOUR HELMET SO THAT IT FITS PROPERLY IN ACCORDANCE WITH POINT 5, THEN
PLEASE DO NOT USE THIS HELMET ! CHOOSE ANOTHER HELMET SIZE OR ANOTHER HELMET MODEL.
• VI. HELMET WITH VISOR
SOME SCOTT HELMET MODELS ARE DELIVERED WITH DETACHABLE VISORS. TO DETACH THE VISOR FROM THE
HELMET, PLEASE FOLLOW THESE STEPS.
• FUGA PLUS HELMET : DETACH THE VISOR BY LIFTING UP THE VISOR FROM THE MIDDLE.
BE CAREFUL : DO NOT TRY TO DETACH THE VISOR BY PULLING THE VISOR FROM THE MIDDLE. YOU COULD
DAMAGE BOTH THE HELMET AND THE VISOR BY DOING SO. TO REATTACH THE VISOR, CENTER IT ON THE HELMET
AND PUSH THE VISOR MOUNTS BACK INTO THE HELMET.
• OTHER HELMET WITH VISOR : PULL THE ENDS OF THE VISOR ON BOTH SIDES FROM THE SNAP LOCKS.
BE CAREFUL : DO NOT TRY TO DETACH THE VISOR BY PULLING THE
VISOR FROM THE MIDDLE. YOU COULD DAMAGE BOTH THE HELMET AND
THE VISOR BY DOING SO. TO REATTACH THE VISOR, CENTER IT ON THE
HELMET AND PUSH THE VISOR MOUNTS BACK INTO THE SNAP LOCKS.
ENGLISH - 8
A
• VII. CARE AND CLEANING
CLEAN YOUR HELMET WITH A SOFT CLOTH OR SPONGE, WARM WATER, AND MILD SOAP.
WARNING : HELMETS ARE MADE OF MATERIAL THAT CAN BE DAMAGED BY MANY TRADITIONAL CLEANING AGENTS.
SOLVENTS OR CLEANING AGENTS WITH A PETROLEUM BASE ARE PARTICULARLY DANGEROUS. THESE CAN DAMAGE
THE HELMET TO SUCH AN EXTENT THAT ITS PROTECTIVE ABILITY IS SIGNIFICANTLY COMPROMISED. DAMAGE IS OFTEN
NOT NOTICEABLE. SCOTT SPORTS IS NOT LIABLE FOR ANY DAMAGES CAUSED BY IMPROPER CLEANING.
• VIII. TRANSPORTATION & STORAGE
WHEN TRANSPORTING OR STORING KEEP YOUR HELMET IN THE SOFT BAG IF SUPPLIED IN THE RETAIL BOX. LET
YOUR HELMET AIR DRY AFTER EACH USE AND THEN STORE IT IN A COOL DRY PLACE. EXCESSIVE HEAT CAN DAMAGE
YOUR HELMET. IN DIRECT SUNLIGHT, DARK EQUIPMENT CASES OR TRUNKS OF AUTOMOBILES CAN BECOME SO HOT
AS TO CAUSE HEAT DAMAGE. HEAT DAMAGED HELMETS ARE RECOGNIZABLE BY UNEVEN OR BLISTERED SURFACES.
EXPOSURE TO SUNLIGHT MAY CAUSE COLOR FADING. SCOTT SPORTS SA SHALL NOT BE LIABLE FOR ANY DAMAGES
AND LOSSES DUE TO IMPROPER STORAGE.
• IX. SALES & HOMOLOGATION
SALES
RESPONSIBLE FOR THE DEVELOPMENT AND COMMERCIALIZATION IN THE EU AND WORLDWIDE IS :
SCOTT SPORTS SA, ROUTE DU CROCHET 17, CH-1762 GIVISIEZ.
DISTRIBUTION USA : SCOTT USA INC., 2733 E. PARLEYS WAY, SUITE #204, SALT LAKE CITY, UT, 84109, USA.
DISTRIBUTION AUSTRALIA / NEW ZEALAND : SHEPPARD INDUSTRIES LIMITED, PO BOX 62 067, AUCKLAND, NEW ZEALAND.
DISTRIBUTION IN THE EU AND WORLDWIDE OUTSIDE THE USA, AUSTRALIA AND NEW ZEALAND :
SSG (EUROPE) DISTRIBUTION CENTER SA, P.E.D ZONE C1, RUE DU KIELL 60, 6790 AUBANGE, BELGIUM.
ALL INFORMATION RELATED TO IMPORTERS IS AVAILABLE AT WWW.SCOTT-SPORTS.COM/COMPANY/DISTRIBUTORS
HOMOLOGATION
ALL DECLARATIONS OF CONFORMITY ARE AVAILABLE AT WWW.SCOTT-SPORTS.COM/CONFORMITY
EU CERTIFIED BY :
ITALCERT, NOTIFIED BODY NO. 0426, V. LE SARCA 336-20126, MILANO, ITALY. CERTIFIED ACCORDING TO : EN 1078
BSI AUSTRALIA & NEW ZEALAND, SUITE 2 LEVEL 7, 15 TALAVERA ROAD, MACQUARIE PARK, NSW 2113, AUSTRALIA.
SAI GLOBAL, 13-15 WADHURST DRIVE, BORONIA, VIC 3155, AUSTRALIA.
EU DIRECTIVES: THE SCOTT HELMETS COMPLY WITH THE PROVISIONS AND SAFETY REQUIREMENTS OF REGULATION
EU 2016 / 425 ON PERSONAL PROTECTIVE EQUIPMENT (PPE CATEGORY II).
ALL HOMOLOGATED HELMETS BEAR CORRESPONDING SEALS STATING THAT ALL OFFICIAL TESTS HAVE BEEN PASSED.
THE SEALS ARE EASILY VIEWABLE AND MAY NOT BE REMOVED.
US DIRECTIVES : SCOTT BIKE HELMETS COMPLY WITH THE PROTECTIVE MEASURES AND SECURITY REQUIREMENTS PROVIDED
FOR IN THE UNITED STATES CONSUMER PRODUCT SAFETY COMMISSION. ALL HOMOLOGATED HELMETS BEAR CORRESPONDING
SEALS STATING THAT ALL OFFICIAL TESTS HAVE BEEN PASSED. THE SEALS ARE EASILY VIEWABLE AND MAY NOT BE REMOVED.
9 - ENGLISH