Mitsubishi Electric PAR-SL101A-E Serie Manual De Instrucciones / Manual De Instalación página 9

4. Operation
After 5
seconds
4.3. Selecting a fan speed (FAN) (Fig. 4-1)
Press the button 4.
• Each time the button is pressed, the setting changes.
Auto
• The available fan speeds depend on the model of the indoor unit.
* The symbols differ depending on models.
Note:
In the following cases, the actual fan speed generated by the unit may be different from the speed shown on the remote controller display.
• The unit is performing the warming-up operation or the defrosting operation.
• Immediately after starting the heating operation (while the system is waiting for the mode change to take effect).
• In the heating mode, the room temperature is higher than the temperature setting.
• In the cooling mode, the room temperature is lower than the temperature setting.
• The unit is in the dry mode.
4.2. Selecting a temperature (Fig. 4-1)
To decrease the temperature, press the
To increase the temperature, press the
• Each time the button is pressed, the set temperature
changes 0.5°C (1°F).
• The setting ranges for the temperature are as follows.
Cool/Dry
19–30°C
67–87°F
* Refer to 6.3. 6) Set temperature range setting in the
installation manual if the set temperature range has been
changed.
When using the AUTO (dual set point) mode
• The set temperature for the current operation mode,
Setting screen
cooling or heating, is displayed.
• When the
perature blinks and the setting screen is displayed.
To change the upper limit (cooling) for the set temperature
range, press the
To change the lower limit (heating) for the set temperature
range, press the
• In the setting screen, press the
the blinking display between the upper limit (cooling) and
lower limit (heating).
• Press the
change the blinking set temperature.
• If no operations are performed for 5 seconds, the display
returns to the previous screen.
* The difference between the upper limit (cooling) and lower
limit (heating) cannot be set to less than 2°C (4°F).
* The AUTO (dual set point) mode cannot be used depending
on the models of the connected indoor and outdoor units.
Heat Auto
17–28°C 19–28°C
63–83°F 67–83°F
or button 3 is pressed, the set tem-
button 3.
button 3.
button 2 to switch
or button 3 in the setting screen to
button 3.
button 3.
Fan
Not settable
en
7