LIMITATIONS OF USE
Note that the ropes must not cross but always lie parallel.
Replacement Parts:
� pulleySAVER replacement part with
soft eye (Art.no. 7350838/-39/-40)
� Sirius Loop 10mm P-S (Art.no. 7350061)
� OD Loop 7mm T (Art.no. 7350606)
PRODUCT INFORMATION WITH REGARD TO EN 795, CLASS B
According to EN 795, class B, the product is suited for a single person. Following the fall of
the belayed person, the rescuer may belay himself/herself at the anchor device that has already
been subjected to one fall. That is to say in type testing, dynamic load was tested twice in suc-
cession, without carrying out adjustments or other reconditioning work on the anchor device.
Warning: The structural anchor (tree / branch) must be suitable, too. Make an adequate esti-
mation taking into account type and condition of the tree etc.
LIMITATIONS OF USE
Never carry out work with this product if, as a result of your physical and mental condition,
your safety might be compromised in scenarios of normal use or in emergencies!
Do not place this product near sharp edges!
Care should be taken to ensure that the rope (or any other part of the system) is routed away
from surfaces that may damage the rope (or any other component), or that suitable and suffici-
ent protection is appropriately placed to ensure the rope and other components are protected.
Keep away from surfaces which may cause damage to the the work equipment e.g.sharp or
abrasive surfaces or edges.
The anchor device shall be used for personal protective equipment and not for lifting devices -
as in rigging operations!
GRAB FUNCTION OF THE FRICTION HITCH
The friction hitch is a means of adjusting the length of the anchor device. In adverse condi-
tions or environments, the function the pulleySAVER may be affected. For example, greater
care may be needed to ensure that the friction hitch grabs reliably. Ice, mud, rain, cold, snow
and tree exudates are examples of localised or climatic conditions that may demand greater
attention from the user. Beware, tree exudates may create conditions similar to those made by
lubricants or adhesives. Contamination of ropes with tree exudates may lead to rope hardening
and reduce friction hitch grab reliability. Maintain ropes so that their function is reliable. Ideally,
ropes should always be dry, clean and perform equally along their entire length.
Great care shall be taken to ensure that objects (such as leaves or twigs) are not trapped by
the friction hitch. Friction levels may be lowered, the grab function may fail, resulting in a de-
scent until the friction hitch meets the stopper To minimise this risk, users shall select the site
of installation in the tree (and other structures where debris may be encountered) to avoid this
situation.
16
� Sirius Loop 10mm P-L (Art.no. 7350060)
� equaLIZA (Art.no. 7350837)
not certified to AS/NZS!