Connecting The Parking Aid - Dometic MagicWatch MWE9004 Instrucciones De Montaje Y De Uso

Connecting the parking aid

7 Connecting the parking aid
I
NOTE
• MWE9008/9004: On some vehicles, the reversing light only
works when the ignition is switched on. In this case, you must switch
on the ignition in order to identify the positive and earth wires.
• MWE9008: You can set a switch-off time for the front sensors if you
are unable to get a speedometer signal for the front sensor control
electronics (neither an analogue connection from the speedometer
nor digital via the CAN bus such as CBI150).
The front sensors are activated by switching on the ignition and
deactivated after the set time (parameter 12).
A 9103555920 switch (accessory) can also be used to activate the
front sensors.
The complete circuit diagram MWE9008 can be found in fig. a.
No. Designation
1 Control electronics for front sensors
2 Black/blue cable: connection to connected positive (+12 V)
3 Brown cable: connection to earth
Yellow cable from the loudspeaker: connection to slot 15 in the plug of the front sensor
4
control electronics
Blue cable from the loudspeaker: connection to slot 3 in the plug of the front sensor
5
control electronics
6 Yellow/black cable: connection to the speed signal from the speedometer (optional)
7 Red/grey cable: connection to the radio's mute connection (optional)
8 Front sensors
9 Control electronics for rear sensors
10 Reversing light
11 Black/blue cable: connection to the reversing light
12 Brown cable: connection to earth
13 Yellow/red cable from the connection cable of the rear sensor control electronics: connection
to the front sensor control electronics, slot 17
14 Brown cable from the connection cable of the rear sensor control electronics: connection to
the front sensor control electronics, slot 5
15 Rear sensors
10
MagicWatch MWE9004, 9008
EN