Connecting The Cam1000 / Bsc01 - Dometic CAM1000 Instrucciones De Montaje

CAM 1000 / BSC 01
Supplement to fig. 2 to fig. 8
Note the following during installation:
• Note the detection range dependent on the position of the camera:
– Operating mode A (red letter „A" on screen) for camera positions with a mounting height
from 2 m to 3 m (fig. 2 to fig. 3):
Visible area: 37 m x 6 m, 165° FOV (field of view)
Active area: 8 m x 4 m
Open cable loop
– Operating mode B (red letter „B" on screen) for camera positions with a mounting height
from 3 m to 4 m (fig. 7 to fig. 5):
Visible area: 19 m x 8 m, 140° FOV (field of view)
Active area: 8 m x 4 m
Closed cable loop
• Use the base if the box body blocks the view to the detection zone (fig. 8).
Supplement to fig. 0
• The system only fulfills the conditions if the monitor is mounted in the area of the right A-pillar
(30° to the viewing axis straight ahead).
7

Connecting the CAM1000 / BSC01

See fig. a
Observe the following:
• As far as possible, use original ducts for laying the cables, or other suitable options such as
paneling edges, ventilation grilles or dummy plugs. If no openings are available, you must drill
holes for the respective cables. Check beforehand that there is sufficient space on the other
side for the drill head to emerge.
• Wherever possible, lay cables inside the vehicle, as they are better protected there than out-
side.
• If you do need to lay a cable outside the vehicle, ensure that it is well fastened (use additional
cable ties, insulating tape etc.).
• To prevent damage to the cables when laying them, ensure that they are always far enough
away from hot or moving vehicle components (exhaust pipes, drive shafts, light systems, fans,
heaters, etc.).
• Attach the cables securely in the vehicles to prevent tripping hazards. This can be performed by
using cable binders, insulating tape or gluing in place with adhesives.
• Protect every through-hole made in the bodywork against water penetration by suitable meas-
ures, e.g. by using a cable with a sealant and by spraying the cable and the cable sleeve with
sealant.
EN
Connecting the CAM1000 / BSC01
9