Trumpf S 420-0 Manual De Instrucciones página 13

Replacing cutters
Pull the plug out of the socket.
Turn or replace moving cutter blade.
•
Unscrew the fastening screw (11).
•
Pull the moving cutter blade (7) out of the bracket,
turn it 180° and reassemble (or mount a new
cutter).
•
Screw in and tighten fastening screw (11).
Turn or replace fixed cutter blade.
•
Unscrew the fastening screw (1).
•
Turn the fixed cutter blade (5) 180° and retighten
the fastening screw (1).
Warning: Note cutting clearance!
Cutting clearance
a Cutter distance = cutting
clearance
1 Fastening screw for the
fixed cutter blade
2 Adjusting screw
3 Fixed blade carrier
5 Fixed cutter blade
6 Shim
7 Moving cutter blade
11 Fastening screw for the
moving cutter blade
E251.doc
Cutting clearance
Cutting clearance "a" should ideally be
0.2 x the sheet thickness to be cut
Example:
Sheet thickness "s" (mm)
Cutter distance = cutting
clearance "a" (mm)
Adjusting the cutting clearance
•
Ensure that the moving cutter blade (7) is in lower
dead centre position (by lightly "tapping" on the
switch several times).
•
Pull the plug out of the socket!
•
Loosely fasten the fixed cutter blade (5) with the
fastening screw (1).
•
Adjust the fixed cutter blade (5) to the desired
cutting clearance using the adjusting screw (2)
(check with feeler gauge).
•
Tighten fastening screw (1).
•
Tighten the adjusting screw (2) slightly.
S 420 - 0
1.5 2.0 3.0 4.0
0.3 0.4 0.6 0.8
Fig. 10100
13
GB