Default Values; Disposal Of The Product - Allmatic BIOS2 24V Manual Del Usuario

12 - DEFAULT VALUES

The BIOS2 24V control unit has the possibility to select the used motor. This allows to set, as defaults, some parameters for the optimal functioning
of the motor.
Here below, the table of the parameters with the default values assigned that depend on the motor.
MENU DISPLAY SHORT DESCRIPTION
SEn
BASIC Obstacle sensitivity with running speed (0 = disabled).
SEL
BASIC Obstacle sensitivity during slowdowns (0 = disabled).
SPn
BASIC Running speed.
spL
BASIC Slowdowns speed.
asL
BASIC Anti slipping / Extra time.
sIT
ADVANCED Intervention time of the current sensor.
SdT
ADVANCED Disabling time of the current sensor during the start of the motor.
UrA
ADVANCED Acceleration ramp amplitude.
DRA
ADVANCED Deceleration ramp amplitude.
DEF
ADVANCED Restore default settings.
NOTE - To know the type of the selected motor, move on the item menu de.f.: the display shows in alternancethe selected motor number. If a
parameter changes (that depends on the motor type), on the display will also appear the letter
13 - WARRANTY
In compliance with legislation, the manufacturer's warranty is valid from the date stamped on the product and is restricted to the repair or free
replacement of the parts accepted by the manufacturer as being defective due to poor quality materials or manufacturing defects. The warranty
does not cover damage or defects caused by external agents, faulty maintenance, overloading, natural wear and tear, choice of incorrect product,
assembly errors, or any other cause not imputable to the manufacturer. Products that have been misused will not be guaranteed or repaired. Printed
specifications are only indicative. The manufacturer does not accept any responsibility for range reductions or malfunctions caused by environmental
interference. The manufacturer's responsibility for damage caused to persons resulting from accidents of any nature caused by our defective products,
are only those responsibilities that come under law.

14 - DISPOSAL OF THE PRODUCT

This product is an integral part of the automation, and therefore, they must be disposed of together. As for the installation operations, at the end of
the life of this product, the dismantling operations must be performed by qualified personnel. This product is made from different types of materials:
some can be recycled, others must be disposed of. Please inform yourselves on the recycling or disposal systems provided for by the laws in force
in your area, for this category of product.
CAUTION! – some parts of the product can contain polluting or dangerous substances which, if dispersed in the environment, may cause
serious harm to the environment and human health.
As indicated by the symbol at the side, it is forbidden to throw this product into domestic refuse. Therefore, follow the "separated collection"
instructions for disposal, according to the methods provided for by local regulations in force, or redeliver the product to the retailer at the
moment of purchase of a new, equivalent product.
CAUTION! – the regulations in force at local level may envisage heavy sanctions in case of abusive disposal of this product.
ALLMATIC S.r.l
32026 Borgo Valbelluna - Belluno – Italy
Via dell'Artigiano, n°1 – Z.A.
Tel. 0437 751175 – 751163 r.a.
http://www.allmatic.com - E-mail: [email protected]
24/24
ITA ENG FRA ESP
DEFAULT VALUES
CUSTOM XTILUS INT VS
50 45 35
70 75 60
100 80 70
50 40 60
0 15 15
2 2
15 15 25
10 15 10
10 10
0 1
c (for example c 1).
TUR NLD
6-1622420
KINEO
MINIART HYPER
400
60 40
60 50
100 100
50 50
15 15
2 2 2
15 15
15 10
5 15 10
2 3 4
rev.5 14/09/2021
50
70
100
50
15
2
15
10
10
5