Tabla de contenido
Idiomas disponibles
Idiomas disponibles
7 - SETTING OF THE STROKE
NOTE - check with the advanced menu de.f.(chapter 9) if the selected motor type is correct, before carring out the learning.
At the first power up, it is necessary to carry out a learning of the stroke for the acquisition of the stroke length and the slowdowns.
After this procedure the installation is complete. To customize the automation, proceed as described in the chapter 8.
WARNING - For a correct functioning of the system, it is absolutely indispensable the use of mechanical stops in opening and closing.
FIG. 4
MOTOR 1
D
E
C
B
Mechanical
stop in
Connect to the
opening
MOTOR 1 output
7.1 - EASY SETTINGS OF THE STROKE
Connect to the MOTOR 1 output the wing which beats. Install an
aventual electrical lock on this wing. MOTOR 1 is always activated first
during opening phase and in second during closing phase.
Carry out a check of the menus and, if needed, customize the settings before
1.
the learning of the stroke.
The slowdowns will be those set in the menu, with the same percentage during
both opening and closing (LSI
The second wing delay will be those set in the menu (default: dLY = 2).
Unlock the automation and move it to the middle of the stroke.
2.
Press at the same time the "UP" and "MENU" buttons for at least 5 seconds
until the display shows LOP.
If the MOTOR 1 DOESN'T MOVE in opening, press the "DOWN" button to stop
3.
the learning. The display shows L--.
Press the "SS" button to restart the procedure: the MOTOR 1 moves in
opening, at reduced speed.
Reached the opening mechanical stop, the motor stops automatically.
4.
WARNING - if the motor doesn't stop automatically, press the "SS"
button.
In this phase the display shows LOP.
If the MOTOR 2 DOESN'T MOVE in opening, press the "DOWN" button to stop
5.
the learning. The display shows L--.
Press the "SS" button to restart the procedure: the MOTOR 2 moves in
opening, at reduced speed.
Reached the opening mechanical stop, the motor stops automatically.
6.
WARNING - if the motor doesn't stop automatically, press the "SS"
button.
In this phase the display shows LOP.
6-1622420
rev.5
C
C
E
E
B
B
D
Mechanical
A
A
stop in closing
B
≠
P).
14/09/2021
A = area at running speed.
MOTOR 2
B = area at slowdown speed.
C = overstroke zone (the movement is at slowdown speed, if the
slowdown is enabled).
D = intervention zone of the amperometric sensor with
E
movement inversion (detects the obstacle).
C
Mechanical
E = intervention zone of the amperometric sensor with the stop
stop in
of the movement and the setting of the reached position as total
opening
closing/opening position (resync area, see MI.A. parameter).
ITA
ENG
FRA
ESP
UP
DOWN
MENU
UP
DOWN
5 seconds
MENU
SS
UP
DOWN
MENU
SS
SS
UP
DOWN
MENU
UP
DOWN
MENU
SS
UP
DOWN
MENU
SS
UP
DOWN
SS
MENU
UP
DOWN
MENU
SS
UP
DOWN
MENU
SS
UP
DOWN
MENU
SS
UP
DOWN
MENU
SS
SS
UP
DOWN
MENU
UP
DOWN
MENU
SS
SS
UP
DOWN
MENU
UP
DOWN
MENU
SS
SS
TUR
NLD
11/24
Tabla de contenido
