Switching The Belt From Transfer To Rounding - JAC LPS Traducción Del Manual De Uso Original

11 SWITCHING THE BELT FROM TRANSFER TO ROUNDING

To switch the belt from rounding to the transfer position:
To switch the belt from the transfer position to rounding, simply reverse the procedure.
The opening and closing angle of the rounder is set using the 2 setting screws located either side of
the belt (fig.5, n°25).
English
Remove the locking pin in order to release the setting screw
(fig.5, n°24).
Release the locking lever (fig.5, n°26) to allow manipulation using the handle.
This operation must be performed on both sides of
When set to rounding, one belt runs in one direction and the other
in the opposite direction at a slower speed.
When set to transfer, both belts run in the same direction.
the belt.
14