Switching On And Off - Metabo KHE 55 KHE 75 Instrucciones De Manejo

17026726_0107 KHE 75 KHE 55.book Seite 11 Freitag, 26. Januar 2007 8:42 08
8.4 Setting chisel position
The Chisel can be locked in 8 different positions.
Insert the chisel.
Press the lock (3) and hold in.
Turn the switch button (2) until it points upwards
(between position
lock.
Turn the chisel in the direction of the arrow until it
is in the desired position.
Press the lock (3) and hold in.
Turn the switch button (2) to position
Release the lock (3) and check that the switch
button (2) has engaged.
Turn the chisel in the direction of the arrow until it
engages.
When a chisel is fitted, only operate the
machine in the chiselling operating
mode.
8.5 Setting impact force and speed
Turn the adjusting wheel (8) to the desired value.
The higher the number, the greater the speed and
the higher the impact force.
The correct setting is found by trial and error.
Example: if soft, brittle materials are being
chiselled, or cracking is to be kept to a minimum,
set the adjusting wheel to "1" to "2" (low impact
force).
For demolition or for drilling into harder materials,
set the adjusting wheel to the highest number
(max.power).
8.6

Switching On and Off

To switch on: press the trigger switch (5).
To switch off: release the trigger switch (5).
9 Tips and Tricks
When working with the chisel hammer, only a
moderate amount of press-on pressure (approx.
20 kg) is required. High press-on pressure does
not increase work capacity and can possibly
shorten the service life of your tool.
In the case of deep bores, pull the drill bit out of the
bore from time to time in order to remove the stone
dust.
10 Maintenance
Motor cleaning: blow out the machine regularly
and thoroughly through the air slots with
compressed air.
and ). Let go of the
.
11 Troubleshooting
Electronic signal indicator (6):
Rapid flashing - CODE! System
The tool was locked with a CODE! Key. The elec-
tronic anti-theft device is active. The tool can be
unlocked again with a CODE! key.
Slow flashing - carbon brushes worn (only KHE 75)
The carbon brushes are almost completely worn. If
the brushes are completely worn, the machine
switches off automatically. Have the brushes
replaced by an authorised service centre.
Continuous light - Service call-up
The tool cut out automatically. Bring the tool to a
Metabo Service Centre.
Rotational speed fluctuations:
High-energy, high-frequency interference can
cause rotational speed fluctuations up to the
maximum idling speed. The fluctuations disappear
again as soon as the interference fades away.
12 Accessories
Use only genuine Metabo accessories.
If you need any accessories, check with your dealer.
For dealers to select the correct accessory, they
need to know the exact model designation of your
power tool.
See page 4:
A Extensive range of chisels for a wide variety of
applications.
B Special grease (for lubricating the tool shanks)
C CODE! key
13 Repairs
Repairs to electrical tools must be carried out by
qualified electricians ONLY!
Any Metabo power tool in need of repair can be
sent to one of the addresses listed in the spare
parts list.
Please enclose a description of the fault with the
power tool.
14 Environmental Protection
Metabo's packaging can be 100% recycled.
Scrap power tools and accessories contain large
amounts of valuable resources and plastics that
can be recycled.
These instructions are printed on chlorine-free
bleached paper.
ENGLISH
ENG
11