Storing A Unit; Removing A Unit From Storage; Technical Specifications - AL-KO BC 4535 Manual De Instrucciones

8

STORING A UNIT

Failure to follow these steps may cause var-
nish to form in the carburettor and difficult
starting or permanent damage following stor-
age.
1. Perform all the general maintenance recom-
mended in the Maintenance Section of your User
Manual.
2. Clean exterior of engine, drive shaft assembly,
debris shield and stringhead.
3. Drain fuel from the fuel tank.
4. After fuel is drained, start engine.
5. Run engine at idle until unit stops. This will purge
the carburettor of fuel.
6. Allow engine to cool (approx. 5 minutes).
7. Using a spark plug wrench, remove the spark
plug.
8. Pour 1 teaspoon of clean 2-cycle oil into the com-
bustion chamber. Pull starter rope slowly several

TECHNICAL SPECIFICATIONS

10
Engine type
Displacement
Power:
Dry weight
Fuel capacity
Cutting width with twin line
Line diameter
Cutting width with cutting blade
Handle
Ignition
Spark plug
Drive
Vibration ISO 7916
Sound pressure value EN 27917
GB 9
times to coat internal components. Replace spark
plug.
9. Store unit in a cool, dry place away from any
source of ignition such as an oil burner, water
heater, etc.
10. Do not transport and store the trimmer with the
blade fitted unless the supplied transport guard is
also fitted.
9 REMOVING A UNIT FROM
STORAGE
1. Remove spark plus.
2. Pull starter rope briskly to clear excess oil from
combustion chamber.
3. Clean and gap spark plug or install a new spark
plug with proper gap.
4. Prepare unit for operation.
5. Fill fuel tank with proper fuel / oil mixture. See
Fuel and Lubrication Section.
FRS 4535
Air cooled 2-stroke engine
42 cm³
1,25 kW
9,1 kg
1,2 l
41 cm
2,4 mm
25 cm
„Bike"-handle
Electronic
NGK BPMR6A or similar
Centrifugal clutch
2
≤ 7,5 m/s
102 dB(A)
Translation of original user instructions