Tabla de contenido
Idiomas disponibles
Idiomas disponibles
en-US
8.4.1
Using a lowering device
34
Decommissioning/removal
DANGER
Risk of fatal injury due to dangerous lone working practices!
Working in pump chambers and tight spaces as well as working where there is a danger
of falling is dangerous work. This work must not be carried out alone! A second person
must be present for safety reasons.
WARNING
A lack of protective equipment may result in hand and foot injuries or risk of
falling!
During work there is a risk of (serious) injury. Wear the following protective equipment:
• Safety gloves that protect against cuts
• Safety shoes
• Safety harness
• If lifting equipment is used, a protective helmet must also be worn!
WARNING
Risk of burns due to hot surfaces!
The motor housing can get hot during operation. This can lead to burns. Allow the motor
to cool down to ambient temperature after switching off!
NOTICE
Use only technically faultless lifting equipment!
Use only technically faultless lifting equipment to lift and lower the mixer. Make sure that
the mixer does not jam during lifting and lowering. Do not exceed the maximum bearing
capacity of the lifting equipment! Check that lifting equipment is functioning properly
before use!
‡
Mixer decommissioned.
‡
Protective equipment put on according to work regulations.
1. Disconnect mixer from power supply.
2. Disconnect and wind up the connection cable.
3. Insert lifting equipment in hoist.
4. Slowly lift mixer and remove it from the basin. During the lifting procedure, remove the
connection cable from the lifting equipment and wind it up.
DANGER! Mixer and connection cable come directly out of the fluid. Wear protective
equipment according to work regulations!
5. Swivel mixer and set it down on a firm surface.
▶ Removal is complete. Clean mixer and set-down location thoroughly, disinfect if re-
quired and store.
WILO SE 2021-05
Capítulos
Tabla de contenido
