Davey DPLGEU Manual De Instrucciones página 22

Figure 6.14
• On the probe and injection housing, under each of the 3 x probe locking nuts, is an o-ring and washer
(refer Figure 6.15). Remove the first probe locking nut on the housing (where it's marked pH);
• Carefully slide the probe locking nut, then the washer, then the o-ring, onto the probe
(refer Figure 6.16);
• The o-ring should not be lubricated when being fitted, please ensure it is completely dry.
ORP
pH
Figure 6.15
Probe locking nut
Figure 6.16
22
Salt
Washer
O-ring
End of probe
▲ CONTENTS