Water Draining From Probe & Injection Point Housing - Davey DPLGEU Manual De Instrucciones

Ocultar thumbs Ver también para DPLGEU:

Tabla de contenido

Idiomas disponibles

• The housing is installed so as water flow moves in the correct direction, shown by arrow markings on

the housing (refer Figure 4.6);

• The housing is installed horizontally (refer Figure 4.7);

• The housing is installed up-flow of the EcoSalt2 cell housing (refer Figure 4.8);

4.4.4. Water draining from probe & injection point housing

IMPORTANT: When installing the probe & injection point housing, the installation

should ensure the probes remain wet, especially during the pump's off period.

If water is found to drain from pipework and especially from the probe and injection point housing, it is possible

that the probes may dry out. Should this occur, please refer to the troubleshooting (Section 12.2) that covers

recovering dry probes. Where pipework is found to drain, the probe housing should be installed to allow a low

point, to keep water in the housing, ensuring the probe ends remain submerged (refer Figure 4.9).

Capítulos

Tabla de contenido