Bosch GCM 10 SD Professional Manual Original página 33

OBJ_BUCH-1128-004.book Page 33 Wednesday, April 15, 2015 4:58 PM
– Switch on the machine.
– Press button 6 and guide the tool arm slowly downward
with handle 5.
– Press the tool arm in the direction of the fence 18 and saw
through the workpiece applying uniform feed.
– Switch off the machine and wait until the saw blade has
come to a complete stop.
– Guide the tool arm slowly upward.
Sawing Workpieces of the Same Length (see figure Q)
The material stop 35 can be used for easily sawing workpiec-
es to the same length.
The material stop can be mounted on either side of the saw ta-
ble extension 36.
– Loosen lock screw 34 and swing the material stop 35 over
clamping screw 57.
– Retighten lock screw 34.
– Adjust the saw table extension 36 to the desired length
(see "Extending the Saw Table", page 31).
Sawing Profile Strips/Mouldings (Floor and Ceiling Strips)
Profile strips/mouldings can be sawn in two different ways:
– Placed against the fence
– Lying flat on the saw table.
Floor Strips/Mouldings
The following table contains instructions for sawing floor strips/mouldings.
Settings
Bevel angle
Floor strip/moulding
Inner corner Horizontal mitre angle
Positioning of
workpiece
The finished workpiece
is located ...
Outer corner Horizontal mitre angle
Positioning of
workpiece
The finished workpiece
is located ...
Bosch Power Tools
Adjusting the Depth Stop (Sawing Grooves) (see figure R)
The depth stop must be adjusted when a trench gap is to be
sawed.
– Push the locking lever 41 and lower the tool arm to the de-
sired position.
– Press button 58.
– Push in adjusting screw 27 until the screw end touches
depth stop 59.
– Release button 58 again.
– Guide the tool arm slowly upward.
Special Workpieces
When sawing curved or round workpieces, these must be es-
pecially secured against slipping. At the cutting line, no gap
may exist between workpiece, fence and saw table.
Provide for special fixtures, if required.
In addition, the cut can be perfomed with or without slide
movement depending on the width of the profile strip/mould-
ing.
Always make trial cuts with the mitre angle setting first on
scrap wood.
Placed
against the
fence
0°
Left side Right side
45° left 45° right
Bottom edge on Bottom edge on
saw table saw table
... to the left of the ... to the right of
cut the cut
45° right 45° left
Bottom edge on Bottom edge on
saw table saw table
... to the left of the ... to the right of
cut the cut
English | 33
Lying flat on
the saw table
45°
Left side Right side
0° 0°
Upper edge against Bottom edge
the fence against the fence
... to the left of the ... to the left of the
cut cut
0° 0°
Bottom edge Upper edge against
against the fence the fence
... to the right of ... to the right of the
the cut cut
1 609 92A 19J | (15.4.15)