Olympus PFL-E01 Manual De Instrucciones página 39

Check the orientation of the cable's 5-pin plug and insert it into the TTL connector's 5-
pin jack on the Case. To facilitate insertion, align the marking on the cable's connector
with the marking on the Case's TTL cable connector.
Turn the connector lock dial on the Case all the way to lock the connection firmly.
To disconnect the underwater TTL cable, reverse the connection procedure. After
disconnecting the cable, screw the TTL cable connector cap back on the Case. Make
sure it is screwed on tightly.
Lock dial screw
CAUTION
：• Always make sure that the case are completely dry before connecting or
disconnecting the underwater TTL cable.
• O-rings are attached to the case's TTL connector caps and the underwater
TTL cable's connectors to keep out water. If any fibers, sand or hair are
attached to an O-ring, the integrity of the waterproof function will be affected
and water penetration may result. Be sure to check and remove any foreign
matter on the O-rings before connecting these connectors.
• Pay attention to the position of the 5 pins when connecting the connectors.
• Do not use excessive force when tightening the lock dial screw on the
cable's connector.
• When the underwater TTL cable is not connected, be sure to put the caps
back on the TTL cable connectors.
E-10
Use this mark to
align the position.
En