Maintenance And Cleaning - Novellini elysium X1 Instrucciones

HOW TO USE YOUR WHIRLPOOL BATH CORRECTLY:
The benefi ts of a whirlpool massage:
The swirling water of a whirlpool bath is naturally soo-
thing and offers many therapeutic benefi ts. In spas,
hydrotherapy is used to stimulate blood circulation, relax
muscles and restore tone to the skin. Basically, it con-
sists in injecting air into controlled jets of water of varying
intensity directed at the body. The jet of warm water and
air bubbles against the body dilates blood vessels and
increases the fl ow of blood to the heart. In addition, the
continuous jet of water has a massaging effect on the
muscles and dilates skin pores, promoting the removal
of toxins and helping to hydrate the surrounding tissue.
Hydromassage is widely used by sports people to relieve
tired muscles after strenuous physical activity, producing
a pleasant sense of relaxation and well-being. The jet
nozzles can be adjusted to direct the jets at the parts of
the body where you want to concentrate the massaging
action. The temperature of the bath water must never ex-
ceed 45°C. The maximum benefi ts are obtained with a
temperature of 36°-37°C.
PRECAUTIONS:
Although hydromassage has been proved to have bene-
fi cial effects, always bear in mind the following simple
rules:
1) The temperature of the bath water must never exce-
ed 45°C. Always fi ll the bath with hot and cold water
mixed. Do not fi ll with boiling hot water fi rst and then
cold water. Remember that the most relaxing effects
are obtained by keeping the bath water temperature
at 36°C/37°C.
2) A whirlpool bath should not last more than 20/30min
at most. The higher the temperature, the less the
bath should last (ideally 36/37°C for approximately
15/20min). Remember that the dilation of the blood
vessels due to the water temperature usually causes a
slight reduction in blood pressure.
3) Persons with serious heart problems or suffering from
hypertension or other serious illnesses should consult
with their doctor before using the whirlpool bath.
4) Children must only use the whirlpool bath under the
supervision of an adult.
5) Elderly and disabled people as well as those with mo-
vement diffi culties should use the whirlpool bath with
care. It is recommended that you seek medical advice.
6) Since the whirlpool provides relaxation, it is best used
after sports activities or at the end of a day's work. Do
not use the whirlpool immediately after a meal.
7) Do not use foaming agents in the bath while the jets
system is in operation as the foaming effect is incre-
ased by pump pressure. Use soap or shampoo only
after you have turned off the jets system.
8) If you really want to use bath salts or other products
providing relaxing, tonic, slimming or other desirable
effects, make sure that they do not produce foam and
that they are well dissolved in the water before turning
on the pump.
9) Keep this manual in a safe place so that it can be con-
sulted by those using the whirlpool bath.
CLEANING AND DISINFECTION:
Deposits of organic material that collect in the pipes du-
ring a whirpool bath promote bacterial growth and, if left
untreated, cause unsanitary conditions and unpleasant
odours. For perfect hygiene, the jets system should be
disinfected immediately after bathing, before draining. To
disinfect, use 50 g of ordinary disinfectant (for example,
liquid bleach) for every 100 litres of water (approximately
half a glass in a bath fi lled to optimum level). Run the
system for few minutes to circulate the disinfectant in the
pipes. Stop the system, allow to soak for 15/20 minu-
tes, then drain the bath. If the bath develops unpleasant
odours after a long period of inactivity, it's a good idea to
disinfect the system before using it again. For hygiene,
if the bath is used consecutively by two or more people,
the system should be disinfected after each use. During
disinfection, turn off the air control to reduce foaming.

MAINTENANCE AND CLEANING:

The bath is made of acrylic and must be cleaned using a
liquid detergent and a soft cloth or sponge. Use a good
quality household liquid detergent. To prevent scale de-
posits, wipe dry using a chammy leather or a soft lint-free
cloth that removes stubborn deposits without leaving tra-
ces. Limescale deposits may be removed using specifi c
detergent products. To restore shine to the acrylic surfa-
ce polish with an ordinary wax polish such as car wax.
DO NOT USE ABRASIVE CLEANERS, ALCOHOL OR
ALCOHOL BASED PRODUCTS, ACETONE OR OTHER
SOLVENTS.
Warning: use of detergents other than those recom-
mended may damage the bath and/or the whirlpool equi-
pment.
SURFACE SCRATCHES:
Small surface scratches can be removed using wet eme-
ry paper (grade 1000) and then smoothing the surface
with abrasive paste. Once the scratch has been remo-
ved, restore surface shine using wax polish. For the best
results, contact your nearest authorised service centre.
TROUBLESHOOTING:
In the event of a problem, perform the following checks
before calling the service centre.
The jets systems does not start:
• When the start button is pressed, the ON-OFF pilot
light must switch on. If it does not, check that the po-
wer supply is on and that the circuit breaker is not trip-
ped.
• If the circuit breaker is tripped, reset it and try switching
on the jets system again. If it trips again, contact the
service centre.
• If the ON-OFF pilot light is on but the water level pilot
light ( ) is not, add water to the bath until the system
restarts. If the pump does not start even when the wa-
ter level is well above the jet nozzles, contact the servi-
ce centre.
• If both pilot lights are on but the pump does not start,
contact the service centre.
The jets system does not stop:
• If the pump continues running and you cannot turn it off
with the ordinary ON-OFF buttons, turn it off using the
circuit breaker and try again. If the problem persists,
contact the service centre.
• Do not, under any circumstances, tamper with the wi-
ring or other electrical parts. Always contact your nea-
rest service centre.
DISPOSING OF THE WHIRPOOL BATH:
To dispose of the whirlpool bath or any part of it, fol-
low local waste disposal regulations. In Italy, Legislative
Decree No. 22 of 5 February 1997 applies. In other EU
countries, the subject is governed by directives 91/156/
EEC, 91/689/EEC and 94/62/EC.
PRODUCT GUARANTEE:
The product is guaranteed as per Italian Presidential De-
cree 224 of 24/05/1988 in Italy and the rest of the EU and
as per CEE Directive 85/374 in terms of product liability.
The Manufacturer guarantees its products against ma-
nufacturing and material defects – provided these are
confi rmed by the authorised personnel of the Company
– for a period of 24 months from the purchase date, as
indicated by the receipt or invoice.
The guarantee covers repairs to and/or replacement of
the parts considered to be faulty. The guarantee does not
cover complete replacement of the product. The guaran-
tee does not cover the lights, warning lights, fuses, glass
parts, mirrors and decoration parts unless these are faul-
ty due to production defects and not due to neglect or
improper use. The guarantee does not cover any parts
and components which are faulty or damaged due to ne-
gligence or carelessness during use, incorrect installation
or maintenance, operations carried out by non-authori-
40
ENGLISH
sed personnel, damage caused during transport or any
other circumstances not due to product manufacturing
defects, such as sudden electricity jolts, lightning, elec-
trolysis, corrosion and, in general, any causes related to
the nature of the water and electrical and water supply
systems in the place where the unit is used. The Pur-
chaser must check that the product is not damaged in
any way before installation and must contact the agent
or authorised assistance centre immediately if any faults
are detected. The guarantee will only be applied on pre-
sentation of a document indicating the purchase date.
In the event of operations without proven defects or to
illustrate how to use the product, all the expenses are
sustained by the Purchaser. Any repairs or modifi cations
carried out by personnel not authorised by the Manufac-
turer will not be covered by the guarantee and will ren-
der the remaining guarantee period immediately null and
void.
The Manufacturer is not responsible in any way for any
direct or indirect damage caused to persons, animals or
things due to failure to comply with all the regulations
in the installation, instruction and maintenance manual
supplied with the product.
Any disputes will be dealt with exclusively by Mantova
Italy, Law Court.
EC DECLARATION OF CONFORMITY:
The manufacturer Novellini Refresh S.p.a. Via della Sta-
zione, 2 46030 Romanore di Borgoforte, Mantova - Italy
Declares under its responsibility that the following pro-
ducts
whirlpool baths mod. 600/30 are in conformity with the
fallowing European directives EEC 73/23, EEC 89/336,
EEC 2004/108 as amended EEC 92/31, EEC 93/68 And
with the following European standards
EN50366
EN55014
EN55014-2
EN60335-1
EN60335-2-60
EN61000-3-2
EN61000-3-3
EN61000-4-2
EN61000-4-4
EN61000-4-5
EN61000-4-6
EN61000-4-11
EN12764-2005
Novellini S.p.a. Romanore di Borgoforte
07
EN 12764
Whirlpool bath designed for personal hygiene.
Resistance to hair entrapment:
Cleanable
Cleaning durability
Romanore di Borgoforte, lì 01.10.2007
Novellini S.p.a.
Gianfranco Novellini
Amministratore delegato
UK
Pass
Pass
Pass