Chapter 3 Doppler And Accessories; Appearance; Display Panel - EDAN INSTRUMENTS SONOTRAX Serie Manual Del Usuario

SONOTRAX Series Ultrasonic Pocket Doppler User Manual

Chapter 3 Doppler and Accessories

3.1 Appearance

Take example for 2.0MHz waterproof probe.
Figure 3-1 Front Panel
Figure 3-3 Top Panel
Figure 3-2 Rear Panel
Figure 3-4 Left Panel
- 6 -
SONOTRAX Series Ultrasonic Pocket Doppler User Manual

3.2 Display Panel

There is a LED at the left-bottom corner of the display panel area of SONOTRAX Lite. When
powered on, the LED turns into green. If the green LED flashes, it indicates that the probe is
disconnected or bad connected. If the LED turns into orange and flashes, it indicates that the
battery is too low to support working. Change for a new battery or charge the chargeable
battery in time.
For SONOTRAX Basic, SONOTRAX Basic A, SONOTRAX Pro, SONOTRAX II and
SONOTRAX II Pro Ultrasonic Pocket Doppler, while self-testing, the LCD display is as
follows:
Figure 3-5 LCD display status while self-testing
Playing
Working Mode
FHR Refresh
Frequency
Battery Indicator
Working Mode:
Here shows which working mode is the Doppler working on.
FHR Refresh Frequency:
When monitor starts, the heart shape flashes, its frequency indicates the FHR refreshing
frequency.
Battery Indicator:
For SONOTRAX Basic, a battery symbol appears on the LCD after powered on, when
battery is low, this symbol flashes; the Doppler will shut down automatically after 7 seconds.
For SONOTRAX Basic A, SONOTRAX Pro, SONOTRAX II and SONOTRAX II Pro, there
are several green panes in the battery symbol on the LCD, which indicates the battery electric
energy. The green panes disappear gradually with the energy consumption. When battery is
low, the empty symbol flashes for 3 times then the Doppler shuts down automatically.
PLAYING:
PLAYING is highlighted when the Doppler is playing the recorded audio signals.
RECORDING:
RECORDING is highlighted when the Doppler is recording.
Communication, Reserved
Recording
FHR Display
Probe Type
- 7 -