Würth 0510 955 710 Traducción Del Manual De Instrucciones De Servicio Original página 20

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 52
DIAG+ modes
During diagnostics with the engine switched off, the device maintains
the power supply of the onboard battery for electrical consumers
(engine cooling, window-lift motors, onboard electronics, etc.) up to
100 A. It maintains a constant voltage from - 12 V to 14.8 V
Voltage adjustment:
The voltage at the battery can be adjusted in 0.1 V steps according
to the specification of the manufacturer in question.
Settings DIAG+ mode
DIAG+
U=13.5V
DIAG+
U=13.2V
Connect the charging clamps: red (+) and black (-) to the battery.
f
Press the START/STOP button.
f
The instantaneous consumed current and the instantaneous
f
voltage are displayed.
Start DIAG+ mode
DIAG+
12V
U=13.5V
CAUTION!
If the current indicated is higher than 10A, then the
battery is discharged. The device starts charging
automatically. Check that all vehicle electrical consumers
are switched off. Wait until the current is below 10 A,
before you carry out the diagnostics.
20
12V
12.0V
12V
12.1V
...
14.8V
DIAG+
12V
U=13.5V
I=12A
SHOWROOM mode
With the engine off, the device enables the use of electrical consum-
ers (engine cooling, window-lift motors, onboard electronics, etc.)
with a constant current of up to 100 A at an adjustable voltage from
12 V to 14.8 V
Voltage adjustment range:
It is possible to adjust voltage at the battery in 0.1 V steps according
to the specification of the manufacturer in question.
Settings SHOWROOM mode
SHOWROOM
U=13.5V
SHOWROOM
U=13.7V
First steps
Connect the charging clamps: red (+) and black (-) to the battery.
f
Press the START/STOP button.
f
The current consumption and the instantaneous voltage are
f
displayed.
Start SHOWROOM mode
SHOWROOM
12V
U=13.5V
Connection without battery (not recommended):
It is possible to supply the vehicle with current without the battery
f
being connected, by pressing the START/STOP button for three
seconds.
appears on the display before the vehicle is
No battery
3
supplied.
12V
12.0V
12V
12.1V
...
14.8V
SHOWROOM
12V
U=13.5V
I=12A
Tabla de contenido
loading

Tabla de contenido