Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Start POWER SUPPLY mode
POWER SUPPLY
U=19.6V
I<50A
Note
In contrast to the other modes, in
the voltage drop in the cables is not compensated. In
this case, the voltage on the display corresponds to the
output voltage of the device (and not the voltage at
the terminals).
Settings menu
Access to the
[Settings] menu item:
Einstellungen
f
3 sec - Settings
MODE
To access the submenus, press the
f
Languages > Restart > Lock Showroom > Check cables >
SELECT
ADVANCED MENU > Reset Memory
Submenu
Languages:
This menu is used to select the languages (using the arrows).
Automatic restart:
The automatic restart function only works in
or
mode. In the event of a power failure, this
[Charging]
Power Supply
function enables automatic restart of the charger and the automatic
restarting of charging. The "Automatic restart" function, is activated
with "Setting – Restart: ON".
«Lock Showroom»:
For locking
mode («Lock button», to prevent misuse).
Showroom
Activate the "Lock Showroom" function with the setting "Einstellung
[Setting] – Lock Showroom: Y".
22
POWER SUPPLY
U=19.6V
I=10A
mode,
POWER SUPPLY
button
Select
,
Showroom
Ladung
Settings menu
EINSTELLUNGEN
Deutsch
EINSTELLUNGEN
neustart:
OFF
EINSTELLUNGEN
lock showroom:
EINSTELLUNGEN
Kabel überprüfen:
START drücken
EINSTELLUNGEN
Advanced menu:
START drücken
EINSTELLUNGEN
Reset Memory:
START drücken
Short cut for Lock Showroom:
can also be activated without accessing the Einstellun-
Lock Showroom
gen [Settings] menu:
Press the
switch.
OFF
f
Press the
switch.
Mode
f
Switch the device back on by pressing and holding
f
The display shows
WÜRTH 100 A
3
Press and hold the
switch until:
Mode
f
is displayed.
Lock Showroom: Y
English
Francais
Deutsch
Nederlands
Espanol
Portugues
Italiano
Russian
...
ON
OFF
Y (yes)
N
N (no)
KABEL
ÜBERPRÜFEN
Advanced menu
Reset Memory
.
Mode
for 3 seconds.
Tabla de contenido
