Technical Characteristics - Nice SMXI Instrucciones Para La Installación

Remote memorising
It is possible to enter a new transmitter in the receiver memory
without using the keypad. A previously memorised and operational
remote control must be available. The new transmitter will "inherit"
the characteristics of the previously memorised one. Therefore, if the
first transmitter is memorised in mode I, the new one will also be
memorised in mode I and any of the buttons of the transmitter can
be pressed. If the first transmitter is memorised in mode II the new
one will also be memorised in mode II but the button activating the
Table "B3" Remote Memorising
1. Press the button on the NEW transmitter for at least 5 seconds and then release
2. Press the button on the OLD transmitter 3 times slowly
3. Press the button on the NEW transmitter slowly and then release
N.B.: If there are other transmitters to memorise, repeat the above steps for each new transmitter
Deleting all transmitters
All the memorised codes can be deleted as follows:
Table "B4" Deleting all transmitters
1. Press the receiver button and hold it down
2. Wait for the Led to light up, then wait for it to switch off
and then wait for it to flash 3 times
3. Release the button exactly during the third flash
N.B.: if the procedure was performed correctly, the Led will flash 5 times after a few moments.

Technical characteristics

Receivers
Decoding
Transmitter compatibility
Frequency
Input impedance
Outputs
Sensitivity
Working temp.
Transmitters
Buttons
Power input 12Vdc Batt. 23A
Absorption
Frequency
Working temp.
Radiated power
SMXI
Rolling code
52 bit FLOR
FLOR, VERY VR
FLOR VERY VR
1 – 2 - 4 2
6Vdc lithium batt.
10mA 10mA
required output must be pressed on the first transmitter as must the
button required to be memorised on the second. You need to read all
the instructions in advance so you can perform the operations in
sequence without interruptions. Now, with the two remote controls
(the NEW one requiring code memorisation and the OLD one that is
already memorised), position yourself within the operating range of
the radio controls (within maximum range) and carry out the
instructions listed in the table.
SMXIS
Rolling code
64 bit SMILO
SMILO
433.92MHz
52ohm
4 (on connector SMXI)
better than 0.5µV
-10°C ÷ + 55°CC
FLO VERY VE
1 – 2 - 4
12Vdc Batt. 23° 6Vdc lithium batt.
15mA 10mA
433.92MHz
-40°C ÷ + 85°C
100µW
Example
TX x5s TX
1s 1s
TX TX TX
TX
Example
RX
RX
SMXIF
1024 FLO combinations
FLO, VERY VE
SMILO
2 2 - 4
12Vdc Batt. 23A
25mA
GB
1s
x1
x3
3°
x5
3