Starting Production - Diamond G2SA77/9 Instrucciones Para El Funcionamiento

5. 3.
INSTRUCTIONS FOR USE

Starting production

Before proceeding with these operations, see "Daily
activation".
When loading the product into the appliance and
unloading it, there is a residual risk of being burnt; this
risk can occur coming into unintentional contact with:
hob - cooking compartment - recipients or material
processed.
Take appropriate measures for personal protection.
Wear protective equipment suitable for the operations
to be performed.
7KH SURGXFWV PXVW EH SODFHG LQ WKH VSHFL¿F FRRNLQJ
containers and positioned correctly on the burners
and/or in the cooking compartment of the oven.
The cooking recipients must have a diameter between
Ø 200 and Ø 375 mm.
:KHQ OLJKWLQJ IRU WKH ¿UVW WLPH ZDLW IRU WKH SRVVLEOH
formation of air inside the gas circuit to fully escape
from the duct.
Lighting open burners (Fig. 1)
Turn the knob while holding it in the piezoelectric position
(Detail A Fig.1).
3RVLWLRQ D ÀDPH PDWFK RU VRPHWKLQJ HOVH RQ WKH SLORW OLJKW
and wait for it to ignite (Fig. 1).
Release the knob after about 20" and check to make sure the
pilot light remains lit.
When the pilot light has been lit, turn the knob (Detail B Fig.1)
WR PLQLPXP RU PD[LPXP WR DGMXVW WKH ÀDPH
Hotplate ignition (Fig. 2)
Turn the knob while holding it in the piezoelectric position (Fig.
2 Detail A), and simultaneously press the piezoelectric button
several times (Fig. 2 Detail B) until the pilot light is lit.
Release the knob after about 20" and check to make sure the
pilot light remains lit (Fig. 2).
The pilot light can be seen through the hole on the panel.
When the pilot light has been lit, turn the thermostat knob to
the desired temperature (Fig. 2 Detail C).
Lighting Gas Oven (Fig. 3)
Turn the knob while holding it in the piezoelectric position
(Fig.3 Detail C). Simultaneously press the piezoelectric button
several times (Fig.3 Detail D) until the pilot light is lit.
Release the knob after about 20" and check to make sure the
pilot light remains lit (Fig.3).
The pilot light can be seen through the hole on the oven top.
When the pilot light has been lit, turn the thermostat knob to
the desired temperature (Fig. 3 Detail E).
THE PRESENT MANUAL IS PROPERT Y OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
A
1
Fig.
A
2
Fig.
A
3
Fig.
- 10 - - 10 - - 10 - 10 10 10 10 10 10 10 0 -
B
B
C
C
B