Installing The Batteries - STACK-ON QAS-1845-E Manual Del Usuario

INSTALLING THE BATTERIES

NOTE: Do not mix old and new batteries.
Do not mix alkaline, standard or
rechargeable batteries.
If your safe includes a shelf, remove it for better
access to the battery compartment. Push the
battery cover locking tab with a screwdriver to
release the cover. Install the (4) AA alkaline
batteries as shown. Replace the cover by
inserting the rear tabs in the slots and snapping
the cover in place.
NOTE: If the batteries are low the
combination buttons will flash red when
pushed. Replace with 4 new AA alkaline
batteries as shown.
PROGRAMMING YOUR OWN
ELECTRONIC COMBINATION
• For security you must program your own
combination after opening the safe.
• Record your new combination on this form or
store your combination on our secure website
at stackon.com under Customer Service. If you
write down your combination you must keep
this information in a secure place, away from
children, not inside the safe.
Press the Reset Button located inside the
1.
safe. Two "beeps" will sound (if the sound is
turned on) and all 3 buttons will flash
blue 2X. You will have 5 seconds to begin
entering your combination or you will have
to start over.
2. Enter your own 3-8 button combination by
pressing any combination of the 3 buttons.
Example: (RIGHT) - (LEFT) - (CENTER) -
(LEFT) - (RIGHT)
For each combination entry a "beep" will
sound (if the sound is turned on) and all the
buttons will light up green. If you delay more
than 5 seconds between entries you will have
to start over from step 1. After you have
finished entering your combination, you will
have 5 seconds to press the Reset Button to
record your new combination or you will
have to start over from step 1.
3. When you press the Reset Button to record
your new combination, there will be two
"beeps" (if the sound is turned on) and all
3 keys flash blue 2X, indicating your new
combination has been recorded.
RESET BUTTON
2
12
40786-1803