Replacing The Battery - koban KMD-11 Manual Del Usuario

CLAMP–ON ADAPTOR AC/DC CURRENT
MEASUREMENTS
1. Set the function switch to the A DC/AC
2. Insert the
negative (COM) jack and the red test lead banana plug into the
positive (V) jack.
3. Press the MODE button until "AC/DC" appears in the display.
4. Press the trigger to open jaw. Fully enclose one conductor to be measured.
5. Read the AC/DC current in the display.
NOTE: The output analog signal Sensitivity of The AC/DC CLAMP–ON
ADAPTOR is 1mV/A

REPLACING THE BATTERY

WARNING: To avoid electric shock, disconnect the test leads from any
source of voltage before removing the battery door.
1. When the batteries become exhausted or drop below the operating
voltage, "BAT" will appear in the right-hand side of the LCD display.
The battery should be replaced.
2. Follow instructions for installing battery. See the Battery Installation
section of this manual.
3. Dispose of the old battery properly.
www.grupotemper.com
clamp–on adaptor
AUTORANGING MULTIMETER
(clamp–on adaptor)
black test lead banana plug into the
KMD-11
position
21