Tabla de contenido
Idiomas disponibles
Idiomas disponibles
KMD-11
AUTORANGING MULTIMETER
OPERATION
WARNING: Risk of electrocution. High-voltage circuits,
both AC and DC, are very dangerous and should be measured
with great care.
1.
ALWAYS turn the function switch to the OFF position
when the meter is not in use. This meter has Auto OFF that
automatically shuts the meter OFF if 15 minutes elapse between
uses.
If "OL" appears in the display during a measurement, the
2.
value exceeds the range you have
range.
NOTE: On some low AC and DC voltage ranges, with the test leads not
connected to a device, the display may show a random, changing reading.
This is normal and is caused by the high-input sensitivity. The reading will
stabilize and give a proper measurement when connected to a circuit.
AUTORANGING/MANUAL RANGE SELECTION
When the meter is first turned on, it automatically goes into
Autoranging. This automatically selects the best range for the
measurements being made and is generally the best mode for most
12
selected. Change to a higher
www.grupotemper.com
Tabla de contenido
