Or 4-Light Kit Assembly - Craftmade C201 Guia De Instalacion

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

10. Light Kit Assembly, 3 or 4-light Options.
Remove 3 screws from top of light kit fitter.
Locate BLUE (or BLACK) and WHITE wires in
switch housing labeled FOR LIGHT KIT
CONNECTION. Remove and discard plastic that
holds these 2 wires together.
Next, locate WHITE and BLACK wires in light kit
fitter labeled FOR LIGHT.
Connect the WHITE wire from the light kit fitter to
the WHITE wire from the switch housing. Connect
the BLACK wire from the light kit fitter to the BLUE
(or BLACK) wire from the switch housing. Be sure
the molex connections snap together securely.
Align holes in light kit fitter with holes in switch
housing. [Note: The gap on the top edge of the
light kit fitter must align with reverse switch on the
switch housing for the proper fit.] Attach light kit
fitter with 3 screws that were previously removed.
Secure all 3 screws with Phillips screwdriver.
Loosen thumbscrews in light kit fitter. Attach glass
shades using thumbscrews. Do NOTovertighten
thumbscrews as glass may crack or break.
Install bulbs included with light kit.
Important: When replacing bulbs, please allow
bulbs and glass shades to cool down before
touching them.
Please proceed to Section 11 on the following page
to complete installation.
switch
housing
reverse
switch
thumb-
screws
(or)
glass
shade
bulb
page 9
motor housing
molex
connections
light kit
fitter
switch
housing
molex
connections
pull chain
extension
light kit
fitter
thumbscrew
pull chain
extension

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

C202C203C204C205C206C207 ... Mostrar todo

Tabla de contenido