Light Kit Assembly, 1-Light Options. Pgs - Craftmade C201 Guia De Instalacion

9. Light Kit Assembly, 1-light Options.
*For Models C201, C202, E201, E202, C207, C208, E207 and E208,
follow instructions on this page.
*For Models C209 and E209, proceed to instructions on page 8.
Remove 3 screws from switch housing cap (at top
of light kit fitter).
Locate BLUE (or BLACK) and WHITE wires in
switch housing labeled FOR LIGHT KIT
CONNECTION. Remove and discard plastic that
holds these 2 wires together.
Connect WHITE wire from switch housing to
WHITE wire from light kit fitter. Connect BLUE (or
BLACK) wire from switch housing to BLACK wire
from light kit fitter. Be sure molex connections
snap together completely.
Align holes in switch housing cap with holes in
switch housing. ( Note: The gap on the edge of the
switch housing cap must align with the reverse
switch on the switch housing for the proper fit.)
Re-insert screws that were previously removed.
Securely tighten all 3 screws with Phillips
screwdriver.
Install bulbs included with light kit.
Important: When you need to replace bulbs, please
allow bulbs and glass shade to cool down before
touching them.
Remove finial, finial plate and threaded washer from
threaded rod on light kit fitter. Raise glass shade in
order to guide pull chains through appropriate holes at
bottom of glass shade. Align threaded rod on light kit
fitter with hole in middle of glass shade and push up
gently, allowing threaded rod to come through hole. (Be
sure pull chain for fan operation does not rub against bulb
during operation.) Secure glass shade with threaded
washer. Note: Do NOT overtighten threaded washer as
glass may crack or break. Align hole in center of finial
plate with threaded rod, allowing pull chains to come
through appropriate holes in finial plate, and push up.
Thread center pull chain through hole in finial and
re-attach finial. Note: Do NOT overtighten finial as glass
may crack or break.
Please proceed to Section 11 on page 10 to
complete installation.
Hg
LAMP CONTAINS MERCURY
Manage in accordance with Spills, Disposal and Site Cleanup
Requirements. In case of breakage, follow clean-up
procedures provided by contacts below.
www.epa.gov/cflcleanup
1-866-284-4010
molex
connections
reverse
switch
switch
housing
molex
connections
light kit fitter
bulb
(or)
threaded washer
page 7
motor housing
switch housing
switch housing cap
light kit fitter
fan pull
chain
blue
white (or black)
wire wire
white wire black wire
glass
shade
finial plate
finial