Fan Assembly. Pgs - Craftmade C201 Guia De Instalacion

5. Fan Assembly.
If you wish to change the hanging length of your fan,
you must remove the hanging ball from the 4in.
downrod provided to use with an extended downrod
(sold separately). [If you wish to use the 4in. downrod,
please proceed to instructions following the dotted line
below.]
To remove hanging ball, loosen set screw on hanging
ball, lower hanging ball and remove stop pin. Slide
hanging ball off the original downrod, A, and slide it
down the longer downrod, B (the top of the downrod
should be noted as having a set screw hole; use this
hole when setting the set screw). Insert stop pin into
top of extended downrod and raise hanging ball. Be
sure stop pin aligns with slots on the inside of the
hanging ball. Tighten set screw securely.
Tip: To prepare for threading electrical wires through
downrod, apply a small piece of electrical tape to the
ends of the electrical wires--this will keep the wires
together when threading them through the downrod.
Loosen yoke set screws and nuts in yoke at top of
motor and remove pin and clip from yoke at top of
motor. Slide downrod through canopy.
Thread electrical wires through downrod and pull extra
wire slack from the upper end of the downrod.
Thread downrod into the motor housing yoke until
holes for pin and clip in downrod align with holes in
yoke--make sure wires do not get twisted. Re-insert pin
and clip that were previously removed. Tighten yoke
set screws and nut securely. Lower canopy to motor
housing.
["Fan Assembly" continued on next page.]
NOTE: The important safety precautions and instructions
appearing in the manual are not meant to cover all
possible conditions and situations that may occur. It
must be understood that common sense and caution are
necessary factors in the installation and operation of this
fan
set screw
A
electrical
wiring
clip
page 4
set screw hole
stop pin
hanging ball
B
downrod
canopy
yoke set screw
pin
motor
housing