Light Kit Assembly (Optional) - Craftmade Yorktown Guia De Instalacion

11. Light Kit Assembly (Optional).

WARNING: Failure to disconnect power supply at
main panel prior to light kit assembly may result in
serious injury.
IF YOU WISH TO USE YOUR FAN WITH A LIGHT
KIT (sold separately), remove finial from switch
housing. Next remove hex nut and lock washer
from top of light kit fitter. (Refer to diagram a.)
Gently push wires from light kit fitter (one by one)
through hole in middle of switch housing and
then screw switch housing onto threaded rod at
top of light kit fitter followed by lock washer and
hex nut that were previously removed. Tighten
hex nut over lock washer for a secure fit. (Refer to
diagram b.)
Connect WHITE wire from light kit fitter to
WHITE wire from switch housing. Connect
BLACK wire from light kit fitter to BLUE (or
BLACK) wire from switch housing. Be sure molex
connections snap together securely. (Refer to
diagram b.)
Connect male plug from the motor housing to
female plug from switch housing, matching up
the colors on the male plug with the colors on the
female plug for correct fit. Be sure that the plugs
connect completely. (Refer to diagram c.)
Align holes in switch housing with holes in switch
housing plate. Re-insert the 4 screws that were
previously removed (page 7, Section 9) and
securely tighten all screws with a Phillips
screwdriver.
Attach glass shade(s) to light kit fitter using the
hardware provided with the light kit. (Refer to
diagram d.)
NOTE: If you are installing a bowl fixture, the
bulb(s) must be installed first.
Install bulb(s) specified by the light kit. (Refer to
diagram d.) If you are installing a halogen bulb, be
sure not to handle glass directly with your fingers as
oil from the skin may shorten the life of the bulb.
IMPORTANT: When changing bulb(s), remember
to allow bulb(s) and glass shade(s) to cool before
touching.
hex nut
lock washer
diagram a
hex nut
lock washer
diagram b
male plug
female plug
diagram c
diagram d
page 9
switch housing
finial
light kit fitter
[representative only]
molex
connections
BLUE (or BLACK)
BLACK
WHITE
WHITE
switch housing
light kit fitter
[representative only]
motor housing
switch housing
plate
switch housing
light kit fitter
[representative only]
light kit
fitter
[representative
glass shade
[representative only]
bulb
[representative only]
only]