Date & Time Set Procedure; Using The Arm Cuff - HoMedics THERA-P BPA-300 Manual

BPA-300-A.qxd 10/5/06 4:20 PM
DATE & TIME SET PROCEDURE
1. To adjust the date/time, press the Set button
located on the back of the monitor.
2. The display will show a blinking number showing
the hour. Change the hour by pressing the
button. Each press will increase the number by one
in a cycling manner. Press the Set button
to confirm the entry, and the screen will show a blink-
ing number representing the minutes.
3. Change the time and date as described in Step 2
above, using the
bers and the Set button
4. A "0" will reappear as the blood pressure monitor is
ready for measurement again.
repeat process to set time and date
Page 13
again
button to change the num-
to confirm the entries.
Press the button
blinking hour
increasing hour
confirm the entry
13

USING THE ARM CUFF

Very Important: Proper cuff size is critical to accurate
measurement.
,
This monitor comes with two sizes of arm cuffs:
Standard Size Fits 9.5"–14.2" (24 cm – 36 cm)
Large Size Fits 13.4"–18.1" (34 cm – 46 cm)
The appropriate cuff is suitable for your use if the
colored arrow falls within the solid color line as shown
below. If the Arrow falls outside of the Solid Color Line, you
need a cuff with another circumference. For circumferences
less than 9.5", contact HoMedics Consumer Relations.
Colored Arrow
Standard
Size Cuff Fits:
MODEL# PP-BPCUFF5
Center tube over
middle of arm
Solid Colored Line
14