Wire Feeder Panel Description - Cebora KINGSTAR 400 TS Manual De Instrucciones

3�7�1

Wire feeder panel description

Fig. 9
AN - Knob
Press knob AN to select LEDs AQ AP AO. Turn to adjust the current/wire speed/thickness shown on display AR�
AR - Display
This shows the value of magnitudes adjusted by means of knob AN�
AO - LED Thickness
Select LED AO, display AR shows the thickness in mm of the workpiece to be welded in relation to the set current
and wire speed. Active in synergic MIG/MAG processes.
AP - LED Wire speed
Select LED AP, display AR shows the welding wire speed in metres per minute. Active in synergic MIG/MAG
processes.
AQ - LED Welding current
Select LED AQ, display AR shows the welding current in amps.
AW - Knob
Press knob AS to select LEDs AT AU AV. Turn to adjust the respective arc length/impedance values shown on
display AS�
In MIG/MAG processes with LED AT on, when AW is turned, the selection automatically shifts to LED AU and arc
length is adjusted.
AS - Display
This shows the value of magnitudes adjusted by means of knob AW�
AT - LED Welding voltage
With LED AT selected, the arc voltage is shown on display AS. When the arc is off, the voltage displayed is the
preset voltage. During welding, the voltage measured by the power source is displayed.
AU - LED Arc length
Select LED AU, display AS shows the welding arc correction (see section 4.3.3).
AV - LED Impedance
Select LED AV, display AS shows the impedance correction (see section 4.3.3).
BA - LED Globular position
With MIG Short process selected, this indicates that the pair of current and voltage values chosen for welding may
give rise to unstable arcs and spatter, material transfer in globular position.
68/109 3301065/A