VENT CAP & TUBE CLAMP INSTALLATION
TUBE
EXHAUST CLAMP
FIGURE 9
JET20 Vent Cap Installation
1. Vent cap reducer slides over 3.5" tube.
2. E xhaust clamp used to cover half of tube and half of vent reducer.
3. Exhaust clamp fastened tight with 9/16" wrench.
JET25 Vent Cap Installation
1. Vent cap butts up against 4" tube.
2. V ent adapter used to cover half of tube and half of 4" vent cap.
3. Vent adapter fastened with Phillips screwdriver.
TUBE
CLAMP
FIGURE 11
ATTACH TUBE TO BURNER BOX
1. S lide Tube over until flush with burner box flange. NOTE
assembled clamp should be loosely fitting on burner box flange.
2. A lign the Clamp so each bolt and nut are on either side of the
seam in which the tube and burner box flange meet.
3. Tighten the Clamp using a 9/16" wrench.
VENT CAP REDUCER
(Shown in FIGURE 9)
(Shown in FIGURE 1 1)
Enerco | Heatstar AG Series Heater
NUTS
SUPPORT BRACKET
FIGURE 10
CLAMP ASSEMBLY
(Shown in FIGURE 10)
1. Make sure to have all hardware parts for assembly:
(1 Base, 2 Support Bracket, 2 Bolts(9/16") and 2 nuts)
2. N OTE: The curved side of the Base should be facing up and flat
side is on the bottom.
3. A lign the Support Bracket so the curved side is facing inwards toward
the clamp with the hole opening then slide the (9/16") Bolt through
to attach the other Support Bracket, use the nut to tighten. Repeat for
other bolt and nut.
8
Operating Instructions and Owner's Manual
CLAMP
9/16 BOLTS
SUPPORT BRACKET
BASE