Control Panel; Programming; Function Of The Buttons, Menu, Up And Down - V2 PD5 Manual Del Usuario

CONTROL PANEL

Perform the electrical connections to the terminal
board, then supply power to the system: the unit
will check the operation status of the display, by
turning all the segments on for 1,5 seconds
8.8.8.8 ; after this, the display will show the
firmware version for 1,5 seconds, for instance
Pr 1.8. Now, the display will show a control panel:
The control panel represents the physical status
of the terminal board contacts and of the program
mode keys: if the upper vertical segment is on,
the contact is closed; if the lower vertical segment
is on, the contact is open (the above picture
shows an instance where the inputs START,
START P, PHOTO1, PHOTO2, and STOP have all
been correctly connected).
AUTO POWER-OFF function: after 50 seconds
from the last intervention the display goes off. It
goes on again at the first change of any input
(START, START P, FOTO1, FOTO2, STOP) or at
the first radio reception of a stored code. If you
push one of the three push buttons (MENU, UP,
DOWN) the display will stay on for 50 seconds.

PROGRAMMING

The PD5 - PD7 unit presents a programming
structure with menus, each of which corresponds
to a function in the unit (function menu) or to a
working time setting (time menu).
Time menus allow adjusting the unit working
times (e.g.: leaf opening or closing time, locking
time, preflashing time, etc.), which can be set
from 0 to 120 seconds with a ±0,5 seconds
interval.
On the other side, the function menu are used to
activate the required functions (e.g. timed lights,
PHOTO1 active as a travelling edge, PHOTO2
inactive, etc.).
Some time menus depend on certain function
menus (e.g.: if the AUTOMATIC CLOSING is
activated – but only in this case – a TIME-OUT
need to be set); then, to simplify the
programming, these time menus have been
placed in the function menus on which they
depend. Specifically, menus AUTOMATIC
CLOSING (Ch.AU), ANTISKID (ASM), and
PHOTOCELL TIME-OUT (Ft.PA) offer some "time
menus" among the selectable options.
FUNCTION OF KEYS MENU, UP,
DOWN
To activate the program mode, proceed as
follows.
• After powering the unit, the display should
show the control panel (therefore, check that
the connections made are correct).
• Press and hold key MENU until the display
shows dEF.
Now the program mode is activated: if no action is
performed within 1 minute, the unit will exit the
program mode and show the control panel again.
When the program mode function is activated,
press key UP or DOWN to select the menus, thus
performing a forward or backward shift (for a fast
shift, press and hold).
Press key MENU to access the settings in order
to change them through keys UP and DOWN.
• Pressing the UP key, the menu functions can
be scrolled from below.
• Pressing the DOWN key, the menu functions
can be scrolled from above.
• Pressing the MENU key, the settings to be
changed can be accessed and selected by
pressing again.
ATTENTION: when the program mode function is
not activated, pressing of the UP key corresponds
to the START command, pressing of the DOWN
key corresponds to the PEDESTRIAN START
command: this way, the service engineer is
enabled to perform the test and the set-up.
The PD5 - PD7 unit can be set up in two different
program modes: DEFAULT PROGRAM MODE or
CUSTOM PROGRAM MODE.
26