V2 PD5 Manual Del Usuario página 48

DISPLAY DATA
LP.PA no / Si
In.LP no / Si
oroL no / Si
ASM
no
t.AAS
St
Cod
Cont
St.P
Cod
Cont
St.Co
tiP.A
tiP.b
StoP
no
invE
ProS
Fot 1
no
APCh
CoSt
Fot 2
no
CFCh
Ch
Ft.tE no / Si
roLL no / Si
CanC no / Si
tEL 1
tEL 2
tEL 3
tEL 4
Fine no / Si
DESCRIPTION
Flashlight in pause
Flashlight with intermittence
Timer function (PD5 only)
Motor antiskid
- Antiskid function is not active
- Antiskid function active with additional time adjustable from 0 to 120 s
START input function
- The START input is enabled to connect TTNC or VRD
- The START input is enabled to connect control devices with
normally open contact
Pedestrian START input function
- The P.START input is enabled to connect TTNC or VRD
- The P.START input is enabled to connect control devices with
normally open contact
Code types (when enabled) on the START and P. START inputs
- If you are using the identification unit (VRD), select this mode
- If you are using the wired digital selector (TTNC), select this mode
Input STOP
- Input STOP not available
- STOP com. stops the gate: START com. starts moving in the
opposite direction
- Input STOP stops the gate: pressing the START com. gate
continues the motion
Input PHOTO 1
- Not available
- Input is available for the connection of the photocell
- Input is available for the connection of the rib
Input PHOTO 2
- Not available
- Input available : photocell is active in closing and also when the
gate is still
- Input available : photocell active during the closing
Photocell operational test
ROLLING CODE MODE
Total deletion of the codes in the memory
Radio input associated to START command
Radio input associated to Ped. START command
Radio input associated to STOP command
Radio input associated to courtesy light (PD5 only)
End of programming
44
DEFAULT MEMO
DATA DATA
no
no
no
2.0 s
Cont
Cont
tiP.A
no
no
CFCh
no
Si
no
no