Roger Technology H70/104AC Instrucciones Y Advertencias Para El Instalador página 36

79 02
Durata luce di cortesia
00
OFF (deactivated)
01
PULSE (brief activation at the start of each operation)
02
ACTIVE DURING THE ENTIRE OPERATION
03 90
SECONDS OF ILLUMINATION AFTER THE END OF THE OPERATION
-
92 98
FROM 2 TO 8 MINUTES AFTER THE END OF THE OPERATION
-
99
output to electric lock (use an external power supply)
80 00
Clock configuration
00
When the clock input is closed (ORO) it opens and then ignores all the commands
01
When the clock input is closed (ORO) it opens and accepts all the commands
90 00
Restoring standard factory values
After having displayed the number
the display shows
(indicated next to the parameter numbers).
WARNING! After the reset, check that the parameters are adjusted to the type of installation.
n0 01
Version HW
n1 23
Year of manufacture
n2 45
Week of manufacture
n3 67
n4 89
Serial number
n5 01
n6 23
FW version
The serial number is obtained by combining the values of the parameters from
example this table shows the values (next to the parameters, they are not default values) from which
you get the serial number
o0 01
Operations performed
o1 23
The number of operations performed is obtained by combining the values of the parameters from
o0 o1
to and by adding 2 zeros. For example this table shows the values next to the parameters
(they are not default values) from which you get the operation number
operations.
h0 01
Operation hours performed
h1 23
The number of manoeuvre hours performed is obtained by combining the values of the parameters
h0 h1
from to
values) from which you get the operation hours number
36
rE S-
flashing which signals a standard factory values reset has taken place
01 23
. For example this table shows the values next to the parameters (they are not default
90
, press the + and - buttons simultaneously for 4 seconds,
45 67 89 01 23
01
01
23
i.e. 123 operation hours performed.
n0 n6
to . For
23
00, i.e. 12300