Roger Technology H70/104AC Instrucciones Y Advertencias Para El Instalador página 20

EN
INDEX
1
Introduction to the instructions and warnings
2 Product technical characteristics
3 Product description
4 Description of connections and fuses
4.1 Motors connection and limit switch
4.2 Standard limit switch configuration
4.3 Standard photocells configuration
4.4 Standard safety edges configuration
5 Radio receiver plug-in
6 Display operation modes
6.1 Commands and safety protections
status mode
6.2 Parameters mode
6.2.1 Changing a parameter
6.2.2 Restoring standard factory parameters
6.2.3 Simplified/extended parameters
mode change
6.3
Standby mode
6.4
TEST mode
7
Installation
7.1
Stroke programming sequence
7.2
Programming sequence to time work
without encoder and with safety edge
7.3
Programming sequence to time work
without encoder and without safety edge
8 PHOTOCELL TEST mode
9 Error reporting
10 Position recovery mode
11 Operating mode extended
12 Inspection
13 Maintenance
14
Disposal
15
Pictures and schemes
1
Introduction to the instructions and warnings
This manual is only intended for personnel
qualified to perform the installation.
No information contained in this document may be
considered of interest to the end user.
This manual refers to controls panels H70/104AC
and H70/105AC for automation composed by one
single-phase asynchronous 230Vac motor.
WARNINGS
Read the instructions carefully before starting the
installation.
20
SHOCK HAZARD
To avoid the risk of electrocution and physical injury
always cut the power before intervening on the
pag.
device. The installation must only be carried out by
20
qualified service personnel according to applicable
20
regulations.
21
Use wires with suitable currents and voltages ratings
21
to make the connections; observe the product's
22
22 technical characteristics. Check the conformity of
22
the grounding and the continuity between the earth
23
on the motor side and the control unit's terminal
23
block.
23
The loads connected to the COR (courtesy) and LAM
23
(flashing) contacts must be protected by a 5x20 fast-
23
acting fuse with a maximum value of 1A 250V.
24
If you connect an electric lock, do not feed it with
24
the built-in power supply for external devices but
25
with a proper external power supply.
25
If You take off the fuse for the protection of 24Vac
25
(F2), it powers off the photocells and relays but the
26
power remains on the control part and the display
26
24 AC
shows
26
to reset the microcontroller. If it is necessary, for
example after modifying the parameter of the gate
27
structure (e.g. encoder and limit switches), You
27
have to cut off the power and wait until the display
27
switches off, after that You have to power on again
27
the control unit.
28
37
37 2
Product description
37
115
The H70/104AC control unit is dedicated to the
control of 1 asynchronous motor for pre-wired
ROGER automations such as sliding and overhead
types.
The H70/105AC control unit can drive any
asynchronous
specifications.
Using motors with encoder, the control unit can
obtain the information on the position of the leaf
and detect impact situations.
You can connect
pushbutton panels, key selectors, a flashing light,
a radio receiver, an open gate light, an electric
lock, a courtesy light and a clock. There are two
configuration levels: a simple one which satisfies
most of the installations and an extended (advanced)
one where it is possible to extensively customise the
behaviour of the automation.
blinking. In this way it is not possible
motor which is
photocells, safety
within the
edges,