Tabla de contenido
ENGLISH
5
00:00
*WELLNESS*
99
Mhz
M
M
4
6
8
Adjusting the time:
Hold 1 pressed until the hours flash.
00:00
00:0
*WELLNESS*
WELLN
Use buttons 1/2 to adjust the hour, press 3 to confirm,
the minutes flash.
18:00
8:00
*WELLNESS*
LLNESS
Use buttons 1/2 to adjust the minutes, press 3 to confirm.
18:30
*WELLNESS*
Shower function:
To activate the water supply, press button 4 and the tap
symbol will appear on the display indicating that the water
for the chosen function can be supplied using the mixer
opening lever.
16:30
*WELLNESS*
Whenever the door between the sauna and shower
compartments is opened, the message "door" will appear
on the display indicating that the door is open and that
no water can be supplied for any function.
To reactivate it, make sure the door is properly closed.
The water supply can be obtained simply by turning on
the radio.
Opening the door between the shower and sauna
compartments will bring up the "door" message again and
the water supply will stop.
Radio:
Press button 5 to switch on the radio.
16:30
M9 107 .05
99
Mhz
Use buttons 4/6 to adjust the volume.
Use buttons 1/2 to adjust the tuning.
Storing programmes:
Use buttons 1/2 to adjust the tuning for the desired station.
Hold down M until OK appears on the display. This can
only be done while M is flashing on the display. Repeat
the operation from M0 to M9.
To call up the stored stations press M.
Chrome therapy:
Press button 3 to switch on the chrome therapy and use
buttons 1/2 to select programmes P0 to P6 with the
following modes:
30
9
P0 changes colour every minute, use P1 to P6 to select
a fixed colour.
16:30
ON
Finnish sauna:
To activate the sauna press 9.
Use buttons 4/6 or 1/2 to select the start hour, then press
7 to confirm.
16:30
16:30
3
ON=16 ,30
N=16 ,3
7
Use buttons 4/6 or 1/2 to select the start minutes, then
press 7 again.
1
16:30
30
2
ON=16 ,30
Use buttons 4/6 or 1/2 to select the duration of the sauna
from 5 to 45 minutes, then press 7 again.
16:30
:30
TIME=
E=
Use buttons 4/6 or 1/2 to select the sauna temperature
from MIN - LOW - MID - HIGH - MAX, then press 7 again.
16:30
6:30
SET=MIN
=MIN
If the start time set is the same as the clock:
The display will show the temperature inside the sauna,
the hourglass lit up steadily and the set duration of the
sauna.
If the start time set is different from that of the clock, the
sauna will start only when the time set as described above
is reached; meanwhile, a flashing sun symbol will appear
on the display.
Once the sauna temperature has reached the optimum
value, an acoustic signal is emitted to indicate that you
can go in to start the sauna.
After this, the hourglass will start to flash indicating that
the counter has started to count down to zero the time
set. Once the counter has reached zero the sauna switches
off. When you have come out of the sauna compartment,
press button 4 to activate the water supply.
16:30
40°C
Menu selection on the display:
To call up the chrome therapy, radio and sauna menus (if
active), press the start button for the appropriate function.
This enables the control buttons for that function.
Alarm:
Press button 8 and an acoustic signal is emitted and all
the selected functions are terminated.
Dismantling the shower valves:
In the event of the formation of lime scale and a resulting
malfunctioning of the shower valves, dismantle the parts
(fig.12/1, 2, 3...). We recommend you immerse the cartridge
in normal vinegar until it is completely lime scale-free.
To ensure correct operation of the thermostatic mixer, the
unit must be supplied from a boiler or a water heater
providing 6 to 7 litres per minute of water at a temperature
of 60/65°C. If an instantaneous gas water heater is used,
this must be of the modulating flame type. The water
supply pressure from the boiler must be from 2 to 5 bar.
INSTRUCTIONS FOR USE:
electrocution Hazard. Do not use electrical equipment
of any type inside the shower enclosure when the
shower is operating.
CLEANING THE SHOWER UNIT:
Caring for your cubicle:
The cubicle panels are made of acrylic and must be cleaned
using a liquid detergent and a soft cloth or sponge. Use
a good quality household liquid detergent. To prevent
scale deposits, wipe dry using a chammy leather or a soft
lint-free cloth that removes stubborn deposits without
leaving traces. Limescale deposits may be removed using
specific detergent products. To restore shine to the acrylic
2ª edición: Marzo 2009
surface polish with an ordinary wax polish such as car
wax. DO NOT USE ABRASIVE CLEANERS, ALCOHOL OR
ALCOHOL BASED PRODUCTS, ACETONE OR OTHER
SOLVENTS.
P0
TROUBLESHOOTING:
Before calling the Service Centre, check that:
- The hoses are properly connected and not kinked.
- Hot and cold water is being correctly delivered to the
wall fittings.
- The water supply system was bled before the shower
unit was installed.
- The mains power supply is reaching the steam generator
and the green Power On LED on the control panel is lit.
If you have followed the instructions and the shower still
does not work, call the nearest Service Centre. The
telephone numbers of authorised service centres are given
6 ,30
in the enclosed list.
WASTE DISPOSAL:
To dispose of the shower unit or any part of it, follow local
waste disposal regulations. In Italy, Legislative Decree No.
22 of 5 February 1997 applies. In other EU countries, the
subject is governed by directives 91/156/EEC, 91/689/EEC
and 94/62/EC.
20'
20'
EC DECLARATION OF CONFORMITY:
The manufacturer New Plastic Via Verga località Pioppelle
46030 Borgoforte (MN) - Italy declares under its
responsibility that the Cubicles Polar, equipped with steam
generator mod. S 400 are in conformity with the following
European directives EEC 73/23, EEC 89/336 as amended
EEC 92/31, EEC 93/68
and with the following European standards:
(EN50366)
(EN55014-1)
(EN55014-2)
(EN60335-1)
(EN60335-2-53)
(EN60335-2-105)
(EN61000-3-2)
(EN61000-3-3)
(EN61000-4-2)
(EN61000-4-3
(EN61000-4-4)
(EN61000-4-5
(EN61000-4-6)
(EN61000-4-11)
20'
Liquid soap
NEW PLASTIC s.r.l.
Carlo Gaidella
R. Amm. Delegato
Tabla de contenido
