Idiomas disponibles
Idiomas disponibles
13
Mount the control LED
Cover the right inner panel with tape to protect it while drilling.
Cut out the template
the center of the hole to be drilled with the scribing iron and drill a pilot hole with ø 2 mm. Then re-drill
with ø 8 mm.
Thread in the connecting cable
Insert the cable in the triple-poled connector shell
2, black cable in position 3). Slide on the cover
Roll up the cable
connect it to the adapter cable on the vehicle.
Connect the display plug to the vehicle.
14
First-time operation and functional inspection of the anti-theft system
Attach the negative lead to the battery.
Activating the system
The immobilizer is activated automatically 15 seconds after the removal of the ignition key.
B
The blinkers shine briefly.
B
The alarm function is not active. You may turn on the ignition (the control LED
can not start the engine. The power supply to the fuel pump and the starter relay is interrupted.
Deactivating the immobilizer
Deactivate the immobilizer with the ignition turned on by pressing button
or by pressing the inductive key
B
The vehicle is fully operational.
Additional (manual) activation of the alarm (with the immobilizer already active)
If the button
when the immobilizer is active and the ignition is turned off, the alarm will also be activated.
B
The blinkers blink twice.
B
After 15 seconds, the control LED
bilizer. After a further 50 seconds, the motion detector is activated.
Attempts to start the engine, disconnect the battery or move the motorcycle will now trigger off
the alarm for 30 seconds, i.e. the siren will sound, the blinkers will flash and the power supply will
be cut off from the fuel pump and the starter relay.
Deactivating the immobilizer and the alarm
The immobilizer and the alarm are deactivated simultaneously by pressing the button
control or by pressing the inductive key onto the control LED
B
The blinkers will flash briefly.
B
The system is now deactivated and the control LED
After deactivation, you have 15 seconds to turn on the ignition; after this time, the immobilizer is acti-
vated automatically once more.
This is Mode A of the system (standard factory setting with automatic activation of the immobilizer and
manual activation of the alarm).
(see last page) and position it on the panel, aligning the edges (lower left). Mark
of the control LED from above and press the LED
and, using a cable tie, shorten it to a total length of approx. 15 cm (6 inches) and
onto the control LED
on the remote control is pressed or the inductive key is pressed onto the control LED
begins to flash and now the alarm is active as well as the immo-
. (Red cable in position 1, white cable in position
.
on the vehicle.
with the ignition turned off.
is off.
20
into the covering.
will be lit) but you
on your remote control
on the remote
