Error Description - Thermo Scientific ADVANCED Serie Manual Del Usuario

Commands
Command Description
Set Ramp Program
Set Ramp Step
Set Ramp On Status
Errors Table:
Errors

Error Description

Not defined, not implemented or incorrectly formatted
Extra characters...
Set value too high
Set value too low
Argument to binary set command not 0 or 1
Set command attempted while in read only mode
Set command failed (e.g. SO 1 with low level)
4
Notes
this will load defaults for all
steps declared by V1
Notes Slave Responds
? Unsupported command
? Format error
? Maximum allowed is [V
? Minimum allowed is [V
? Value must be 0 or 1
? Mode is read only
? Failed
All messages from master and slave are terminated with a carriage return [CR]
Master Sends
SRP [v1,v2,v3,v4]
V1 #of steps
V2 variance
V3 cycles
V4 start temp
SRS[v1,v2,v3]
V1 step #
V2 end temp
V3 duration
SRO [V] S,E,P
Start, End,
Pause/resume
MIN
Sample Slave Response
(echo off)
OK
Note: If unit allows more than
one ramp the ramp number must
first be set.
OK
Note: If unit allows more than
one ramp the ramp number must
first be set and SRP defined.
OK
Note: (P)pause toggles
Pause/resume
]
MAX
]
Alternate units