Command Description - Thermo Scientific ADVANCED Serie Manual Del Usuario

Commands

Command Description

Read Firmware Version
Read Firmware Checksum
Set Displayed Setpoint
Set Setpoint X (X = 1 to 5)
Select Setpoint X (X = 1 to 5)
Set High Temperature Fault
Set High Temperature Warning
Set Low Temperature Fault
Set Low Temperature Warning
Set Proportional Heat Band Setting
Set Proportional Cool Band Setting
Set Integral Heat Band Setting
Set Integral Cool Band Setting
Set Derivative Heat Band Setting
Set Derivative Cool Band Setting
Set Temperature Resolution
Set Temperature Units
Set Unit On Status
Set External Probe On Status
Set Auto Restart Enabled
Set Energy Saving Mode
Set Pump Speed
Set Ramp Number
Note 1: SSX is a content dependent command. If SSX is immediately followed by a space and a value, the value is
assigned to setpoint x. For example, if setpoint 2 is currently 37° and SS2 45<cr> is issued, setpoint 2 is changed to 45°.
If SSX is immediately followed by a carriage return the controlling setpoint is changed to X. Foe example, if the
controlling setpoint is 3 and SS<cr> is issued, the controlling setpoint is changed to setpoint 2.
Notes
See Note 1
See Note 1
All messages from master and slave are terminated with a carriage return [CR]
Master Sends
RVER
RSUM
SS [V]
SSX [V]
SSX
SHTF [V]
SHTW [V]
SLTF [V]
SLTW [V]
SPH [V]
SPC [V]
SIH [V]
SIC [V]
SDH [V]
SDC [V]
STR [V]
STU [V] C,F,K
SO [B]
SE [B]
SAR [B]
SEN [V]
SPS [V] L,M,H
SRN [V]
Sample Slave Response
(echo off) Alternate units
[V]
[V]
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
3