T-Connector Wiring Kit
INSTALLATION INSTRUCTIONS
1. Read instructions thoroughly before beginning.
2. Open the vehicle's rear hatch and remove the plastic threshold
cover, floor coverings, cargo trays, and access panels. Remove the
cargo tiedown hardware and pull out
slightly on the left and right side interior
trim panels (Fig. 1).
3. Locate the vehicle's tail light wiring
harness behind the interior trim panels
on each side. The harness will have
connectors similar to those on the T-
Connector Harness (Fig. 2).
4. Beginning on the left (driver's)
side, separate the vehicle harness
connectors by pressing on the locking
tab and carefully pulling apart. Insert
the T-Connector ends with the Brown
and Yellow wires into the separated
vehicle harness connectors. Press
firmly together to ensure the locking
tabs engage.
5. Route the T-Connector ends containing the Green and Red wires
below the threshold to the right (passenger) side. Repeat step 4 using
the T-Connector ends with the Green and Red wires.
6. Strip 5/16" of insulation from the legnth of 12 Ga. Black wire
provided and connect it to the Black wire on the T-Connector's black
box using the butt connector provided.
7. On the left (driver's) side of the vehicle, mount the T-Connector's
black box on the floor of the vehicle using the foam tape provided.
Note:Ensure proper clearance for all trim panels, liners and
Fig. 1
Fig. 2
