Anti-Scale Filter; Automatic Switch-Off - Silvercrest SDB 2400 F4 Instrucciones De Uso

Anti-scale filter
The iron has an anti-scale filter (ANTI CALC). This is a permanent water filter. It
■
does not need to be replaced or maintained.
■ To preserve the function of the water filter, fill the water tank only with tap
water or distilled water. Do not use any additives. These could damage the
water filter.
Automatic switch-off
This steam iron is fitted with an automatic switch-off system. This stops the iron
from heating up.
If the iron is resting on the sole of the iron q and is not moved for about
30 seconds, you will hear a warning beep and the control lamp for the
automatic switch-off
the automatic switch-off, lift up the iron and move it gently from side to side.
The control lamp for the automatic switch-off
heat up again.
If the iron is on its base 0 and is not moved for about 8 minutes, there will be a
warning beep and the control lamp for the automatic switch-off
iron will stop heating up. To deactivate the automatic switch-off, lift up the iron and
move it gently from side to side. The control lamp for the automatic switch-off
goes out and the iron will heat up again.
NOTE
► The automatic switch-off is not intended as a substitute for removing the
plug from the mains power! This is merely intended to reduce the fire hazard
if you forget to switch off the iron!
■ 10 │ GB │ IE
6 will flash. The iron will stop heating up. To deactivate
6 goes out and the iron will
6 flashes. The
SDB 2400 F4
6