Product Description And Specifications; Intended Use; Product Features - Bosch GTS 10 J Professional Manual Original

OBJ_BUCH-1325-004.book Page 29 Tuesday, September 13, 2016 1:06 PM
Symbols and their meaning
Wear ear protectors. Exposure to noise
can cause hearing loss.
Wear safety goggles.
Observe the dimensions of the saw blade. The hole diameter
must match the tool spindle without play. Do not use reduc-
ers or adapters.
When changing the saw blade, pay attention that the kerf
width is not less than 2.3 mm and the blade body thickness
not greater than 2.3 mm. Otherwise, there is danger that the
riving knife (2.3 mm) becomes wedged in the workpiece.
The maximal possible workpiece height is 79 mm.
Left side
Indicates the rotation direction of the
handwheel for lowering (transport
position) and raising (working posi-
tion) the saw blade.
Right side
Indicates the position of the locking le-
ver for locking the saw blade and for
adjusting the bevel angle (saw blade
tiltable).
Bosch Power Tools
Product Description and Specifica-
tions

Intended Use

The power tool is intended as a stationary machine for making
straight lengthways and crossways cuts in hard and soft-
wood, as well as in particle and fibre board. In this, mitre an-
gles from –60° to +60° as well as bevel angles from –2° to
47° are possible.
When using appropriate saw blades, sawing aluminium pro-
files and plastic is also possible.

Product Features

The numbering of the components shown refers to the repre-
sentation of the power tool on the graphic pages.
1 Scale for clearance of the saw blade to the
2 Guide groove for parallel guide 10
3 Angle stop
4 Recessed handles
5 Guide groove for angle stop
6.1 Blade guard with clamping lever*
6.2 Blade guard with clamping screw and side protector*
7 Vacuum connection on the blade guard
8.1 Clamping lever for locking blade guard 6.1
8.2 Clamping screw for locking blade guard 6.2
9 Saw table
10 Parallel guide
11 V-guide groove on saw table for parallel guide
12 Mounting holes
13 Carrying handle
14 Saw-table extension
15 Tensioning lever for saw-table extension
16 Fastening bracket for saw stand GTA 600
17 Locking lever for adjustment of bevel angles
18 Handwheel
19 Crank for lowering and raising the saw blade
20 Safety flap of On/Off switch
21 Hex key (5 mm)
22 Ring spanner (23 mm)
If required, lubricate the
power tool at the indicat-
23 Push stick
ed locations.
24 Insert plate
25 Riving knife
26 Saw blade
27 Lens
28 Profile rail
29 Cable holder
Read all safety warnings and all instruc-
tions. Failure to follow the warnings and in-
structions may result in electric shock, fire
and/or serious injury.
parallel guide 10
1 609 92A 2C1 | (13.9.16)
English | 29