Menu 2 Programming - BFT Espas 20I Nstrucciones De Instalacion

15 - MENU 2 PROGRAMMING

To enter menu 2 "ADMIN" when the station is switched on, wait for the firmware version and
the date to appear and press the joystick centrally.
Parameter Description
Input
Display of the I/O state connect-
ed to the card: photocells, loops,
etc. ONLY READING
If the input is active, the corre-
sponding code is displayed (see
Values)
Language
The language used by the station
is used
Change with UP and DOWN,
confirm with PUSH
Address.
Station configuration
Change with UP and DOWN,
confirm with PUSH
Gate Station type and name
Change with UP and DOWN,
confirm with PUSH
Warmer Thr.
Express the temperature (in °C)
below which the heating resistor
is activated. Change with UP and
DOWN, confirm with PUSH
46 - Espas 20I
Values
0=Ticket request button pressed
1=INOPZ1 input active
2=Ticket slot photocell active (only
with KPM printer)
3=INOPZ3 input active
4=Detection loop active
5=Safety loop active
6=Barrier limit switch active
7=Entry station disabling active
(terminals 12/13)
To change the language, use the
EspasConfy software
033=Entry station 1
034=Entry station 2
035=Entry station 3
041=Exit station 1
042=Exit station 2
043=Exit station 3
049=Table validator1
050=Table validator2
051=Table validator3
057=Counter panel 1
058=Counter panel 2
059=Counter panel 3
IN1...IN3 = Input 1, 2 or 3
EXIT1...EXIT3 = Exit 1,2 or 3
POS1...POS3=Issuer 1,2 or 3
COUNT1...COUNT3 = Kit
NORA 1, 2 or 3
0...255
Default
-
IT
033
IN 1
35