Master Reset; Sensor Calibration - Siemens SINTRANS LR25 Guia De Inicio Rapido

Set Device Tag via AMS Device Manager:
a) Launch AMS Device Manager – AMS Device Manager.
b) From the Device Connection View, right click on the FF Network icon and select
Rebuild Hierarchy.
c) Right click on the device icon, and choose Rename from the menu.
d) Enter a device tag and press Enter.
Startup
1) Launch AMS Device Manager – AMS Device Manager. (If AMS already running, go to
step 4.
2) From the Device Connection View, right click on the FF Network icon and select Rebuild
Hierarchy.
3) Double-click the device icon to open the startup screen. The startup screen shows device
identification details, and a navigation window on the left-hand side of the screen. (The
Block Status will show Out of Service at initial startup.)
4) Next, complete a master reset.

Master Reset

A master reset is recommended before first configuring a new device. (Block Status must be
Out of Service to perform a Master Reset.)
1) Navigate to Configure/Setup > Resource > Operation > Methods and click to open the
dialog window.
2) In the General field, click on Master Reset and click Next to perform reset to factory
defaults. Click Next to accept default reset to Factory Defaults.
3) Click FINISH then restart AMS to reload settings. Next, scan the device.
Scan Device
Scan Device uploads parameters from the device (synchronizes parameters) to AMS Device
Manager.
1) Open the pull-down menu Actions – Scan Device (upload parameters from the device to
AMS).
2) The next step when adding a new device is to configure and calibrate the device via the
Quick Start Wizard.

Sensor calibration

The LR250 FF does not need to be calibrated, only configured using the Quick Start Wizard
below.
Configuring a new device
Configure a new device using the Quick Start Wizard, found in the Resource Block of the
function group Configure/Setup.
Page EN-22 SITRANS LR250 (FF) – QUICK START MANUAL 7ML19985XN82