Operation And Funtion; Knob Setting - koban KDP6 Manual Del Usuario

KDP6
Wall presence detector

Operation and funtion

Knob setting

The default setting of each knob
before ex-factory is as following:
METER "+", TIME:"Test", LUX:
LED mode: "watch" (See FIG 17).
METER knob setting
• Set METER knob value at
the position of "-"for the
"smallest field of view"
• Set METER knob value at the
position of "+"for the "largest
field of view"
• Set METER knob value at the
position between "-" and
"+" for "desired field of
view"
Instructions manual |
,
36
TIME knob setting
• Set TIME knob value at the
position of "Test", start to walk
test, the load and LED turn on 2
sec. then turn off while detector
is triggered.
• Set TIME knob value at the
position of "-", the minimum
delay time will be 6 sec.
• Set TIME knob value at the
position of "+", the maximum
delay time will be 10 min.
• Set TIME knob value at the
position of "
switch will receive 1 sec. signal
once KDP6 is triggered, then the
light ON 1 sec., OFF 9 sec.
• To adjust the TIME knob in
between "-"& "+" according
to users desire.
LUX knob setting
• When setting the LUX knob to
• " ", the detector will operate
the lighting only in the darkness.
• When setting the LUX knob to
• " ", the detector will operate
the lighting at any light level.
• To adjust the LUX knob
according to users needed.
LED mode setting
LED mode features OFF/warning/
Watch under function where there
is no setting TIME knob "Test"and
standby status. The mode is selected
according to users desire and refer to
following chart for details.
www.grupotemper.com
", staircase time