Installing The Battery; Operation - koban KDT 8900 Manual De Instrucciones

KDT 8900
Phase digital power clamp meter

Installing the battery

WARNING
The measurement must be done
only with the cap on the probe
tip.
NOTE: if your detector does not work
properly, check the batteries to make
sure are still good and are properly
inserted.

Operation

Checking the AC electrical voltage
in a shocket
WARNING
Risk of electrocution. High-
voltage circuits, both AC and DC,
are very dangerous and should be
measured with great care.
WARNING
Risk of electrocution. Keep hands
and fingers on body of the
detector and away from the probe
tip.
Instructions manual | 10
1. Open the battery cover (G) by
simultaneously pressing the top
of the pocket slip (F) and pushing
the battery cover (G) out.
2. Insert two AAA batteries (Ensure
the correct polarity).
3. Replace the battery cover.
WARNING
Risk of electrocution. Before using
to check for voltage in a socket,
always test the detector on a
known live circuit to verify that
the detector is workeing properly.
1. Press the Power Button (D) to
turn the detector on, meanwhile
the green light is on.
2. Touch the probe tip(A) to a cord
plugged into the socket, or insert
the probe (A) directly into a
socket.
3. If AC electrical voltage is
present, the red LED light (C)
www.grupotemper.com