Trouble Shooting - koban KDP6 Manual Del Usuario

Trouble shooting

When KDP6 works abnormaaly, please check assumptive problems
and suggested solutions in following table that will hopefully to solve
your problems.
Problem Possible cause
Lighting device 1.Power does not turn on.
does 2.Wired incorrectly.
not turn on 3.LUX knob adjusted incorrectly.
4.Malfunctioned load.
Lighting device 1. Incorrect time setting
does not turn 2.Detector is nuisance
off triggered.
3. Wired incorrectly.
LED does 1.Exceeding the detection
not turn on range.
2.No power supply.
3.Wired incorrectly.
4. TIME knob is not located to
TEST position.
Nuisance There are heat sources, highly
triggering reflective objects or
any objects which may be
swayed in the wind within the
detection coverage.
www.grupotemper.com
Wall presence detector
Suggested solution
1.Switch on the power
2.Refer to wiring diagrams
(FIG.5) and check if the load is
malfunctioned.
3.Check if LUX knob are set to
the correct position.
4.Replace the disabled
load with a new one.
1.To test the delay time specified
on TIME knob and check
detector is nuisance triggered if
lighting device does not turn off
as the delay time is up.
2.Keep away from detection
coverage to avoid activating
detector while doing the test.
3.Make sure load and wires are
connected correctly.
1.Walk in the effective detection
range
2.Switch on the power.
3.Refer to wiring diagrams
4. TIME knob must be located to
TEST position
Avoid aiming the detector
toward any heat sources, such as
air conditioners,
electric fans, heaters or any
highly reflective surfaces. Make
sure there are no swaying
objects within the
detection coverage.
Instructions manual |
KDP6
41