Troubleshooting - Roca Euret Manual Del Usuario

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

11

Troubleshooting

Symptom
No response
(The indicator not on)
No flushing
There is response
(The indicator flickers)
No flushing or bad flushing result
Not enough water
Water can't stop
(The indicator not flickering)
No flushing but the indicator flickers
Other
Probable Cause
1. No batteries or wrongly installed (A35945E..0 ,
A35945S..0)
2. A/C power source outage or power cut
(A35945M..0 , A35945T..0)
3. There are sundries in front of a sensor The sensor
window is dirty.
4. The wire connection is not good or wrongly
connected.
1. The installation is just finished.
2. The inlet valve is not fully opened.
1. The inlet valve is not opened.
2. The filter is blocked.
3. The water pressure is too low.
There is dirt inside the solenoid
valve.
The batteries are run out
(A35945E..0 , A35945S..0)
Please contact with the dealer for further service.
10
Action
1. Check the batteries
2. Check the power source
3. Check the sensor window
4. Check the wire connector
1. Wait for 60 seconds
2. Fully open the inlet valve
1. Fully open the inlet valve.
2. Clean the filter
3. Contact the water supplier
Clean the IR filter
Change the batteries
Tabla de contenido

Solución de problemas

loading

Tabla de contenido