Installation Procedure - Roca Euret Manual Del Usuario

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

3

Installation procedure

Refer to the following diagram to drill fixing holes, insert fisher bolt and install the hanging bracket. Pay attention to the relative
position between brackets and inlet/outlet pipes to avoid interference.
1.
150
Horizontal outlet inner diameter Ø52
Note : If the urinal can not be hung on the bottom bracket, just put a washer about 6mm thick at the back of the bracket.
Follow the bottom diagram to install the angle valve and discharge pipe, to make the insertion easier, we suggest apply some lubri-
cant (without erosion to rubber and pipe ) onto the inside of the discharge pipe.
Cleaning the water supply pipe before installation and avoid using water with impurities, sour or alkaline processing water or
contaminating water.
Connect to main power supply(Only A35945M..0 , A35945T..0)
1. Locate the switching power inside the valve unit and pass the ac cable through the hole.
2. Connect switching power cable and main power supply into the cable connection box.
3. Close cables connection box and locate it on a free space in order not to interfere with the installation of the urinal on the wall.
1. For safety concern, the power could only be supplied to product once the installation is completed.
2. AC power cable is forbidden to connect with valve box or valve assembly.
3. Power supply is supposed to be installed with appropriate thermal fuse (10~15Amp) or other protection devices.
4. In case that you are going to apply with other methods for connecting the power cord, please be sure the wire is firm and
insulated.
1
AC power assembly
Ø8
600
2
Switch power
Input : AC100-240V~
Close
2.
3
4
Tabla de contenido

Solución de problemas

loading

Tabla de contenido